LAZBOY Roxy Conference Chair OFD-LAZ550-BLK User manual

Roxy
Conference Chair
MODEL OFD-LAZ550-BLK / OFD-LAZ550-GRY
PROFESSIONAL

2
D
C
B
A
E1 E2 G
F
1” Screws X8 1-1/4”Screws X4
IJ
Allen Key X1
H
Casters X5
Left Arm X1
Star Base X1 Gas Lift X1 Seat Plate X1
SeatCushion X1 Back Cushion X1
Right Arm X1
PARTS
D1
D2

3
Step 1
Place the star base (B) upside down and insert 5
casters (A) into the holes on the star base (B).
Step 2
Turn the star base (B) over and insert the gas lift (C)
through the center hole on top of star base (B).
B
B
C
A

4
Step 3
Tighten the brackets of arms (E1 & E2) onto the bottom of the seat cushion (F) (with front of arms facing the front of
seat cushion) by using 1” screws (H).
*Note: Tighten the screws completely.
J
H
H
F
E1
E2

5
Step 4
Align the back cushion (G) with the seat cushion (F) and attach the back support plate onto the bottom of the seat
cushion (F) by using 1-1/4” screws (I).
*Note: Tighten the screws completely.
G
F
IJ

6
Step 5
Attach seat plate (D) to the bottom of the seat cushion (F) (with the front of the seat plate facing the front of seat
cushion). Attach by using four 1” screws (H) for the holes of the seat plate (D) and tighten the screws using allen key (J).
*Note: Tighten the screws completely.
J
F
D
HH

7
Step 6
Insert levers (D1 & D2) of seat plate (D) to the pre-attached cable lever receivers on the underside of seat cushion (F). Push down the
key on the receivers to pull out the levers.
*Note: Fix the cable for the seat plate into the plastic clips attached to the bottom of the seat cushion.
Push
Disassemble the lever
Insert
Assemble the lever
D
D1
D2
F

8
Step 7
Position the assembled chair upright with the seat plate facing down. Insert the gas lift (C) into the center hole of the
seat plate (D) and press down until fully engaged.
D
E
C

9
Operating Instructions
Function Instruction - 1
To Adjust Seat Height:
While seated, lean forward and reach under the right
side of the chair to nd the lever. Lift the lever and
raise your body up slightly to allow the chair to rise to
the desired height. Once desired height is reached,
release lever to lock chair at desired height. To lower
the seat, lift the lever while seated. The chair will
descend until the lever is released or the chair reaches
the bottom position.

10
Function Instruction - 2
To Operate Tilt Lockout:
Reach under the left side of the chair to nd the
lever. Flip the lever down and lean back to allow
the chair to tilt backwards. Flip the lever up to lock
the chair angle while the desired position is reached.