LAZBOY Blake User manual

Page 1 of 5
Blake Dining Table
Owner’s Manual
If you have any problems with this product, DO NOT RETURN IT TO THE STORE.
CALL OUR CUSTOMER SERVICE HOT-LINE AT
866-851-3004
Monday – Thursday, 8AM-5PM (EST)
Friday, 8AM-4PM (EST)
La-Z-Boy® is a registered trademark of La-Z-Boy Incorporated and is used under license to BJI, Inc.
© 2016 La-Z-Boy Incorporated.

Page 2 of 5
For warranty and other helpful information, please call us at 866-851-3004, Monday – Thursday 8am - 5pm (EST), Friday
8am – 4pm (EST).
Care and Maintenance
Be careful to never allow water to build up in frames as this will cause corrosion and freeze damage in cold climates. Wash all
frames with a solution of mild soap and water. Rinse with clean water and dry with a soft absorbent cloth towel. Frames can be
treated with a liquid wax for maximum protection against UV rays and/or salty damp air. If your set includes cushions, slings,
and/or an umbrella they may be cleaned by hand with a solution of soap and water with a clean water rinse. (Never machine
wash cushions, slings or umbrella covers as this will result in shrinkage or damage).
After cleaning cushions tip on end and allow to drip dry. (Never use a commercial or home dryer to tumble dry fabric goods).
Do not use bleach or solvents to clean any product! This will void the warranty.
Lack of original receipt will void warranty!
CAUTION: Read all the instructions before assembly. Failure to do so may result in faulty assembly and potential injury!
Assemble product on a soft, non-abrasive surface such as a carpet or cardboard to avoid damaging the item. Seek assistance to
assemble bulky or heavy items. After final alignment, make sure all bolts and nuts are securely tightened with screw head covers
pressed in place.
Note: Do not allow children to play with plastic wraps or small parts to prevent potential choking hazard.
PART LIST
PARTS NO. PARTS NAME PARTS QTY
AA M8*25 Hex bolt
16
BB M6*15 Hex bolt
2
CC M8 Hex bolt washer
16
DD M6 Hex bolt washer 2
EE M8 Hex bolt cap
16
FF M6 Hex bolt cap 2

Page 3 of 5
GG M6 Wrench
1
HH M8 Wrench
1
A Table top 1
B Table leg
2
C
Connector 1

Page 4 of 5
Assembly Steps:
Step 1: Attaching the table legs. (Figure 1)
Step 2: Attaching the table top. (Figure 2)
Figure 2
Figure 1

Page 5 of 5
Step3: Positioning the table. (Figure 3)
WARNING: Do not place heavy items on the table top.
WARNING: An umbrella base must be used at all times when an umbrella is in use. Do not use an umbrella in
the event of wind, rain, hail, sleet, snow, or any other inclement weather.
WARNING: Do not sit or stand on the table top.
Figure 3