Lean Cars ABL-1602 User manual

User Manual
Please read the instructions carefully before use
Performance Standard: GB6675-2014

1
Catalogue
Instructions before Use
Specification
Safety and Points for Attention
List of Critical Components
Exploded View
Assembly Order Diagram
The Function Diagram and Operation Method
Charge Mode
Simple Screen and Maintenance of Fault
Instructions before Use:
Dear customers, please read this manual carefully before you use the
products. Because it can tell you the correct method of installation and
operating procedures to avoid damaging the products or hurting your
children caused by incorrect operating procedures and without
understanding safety knowledge. Please keep this instruction for future
use and place it in easily accessible place.
Specification:
The external size
of vehicle 133x85x87cm The battery model 12V7AH (12V10AH)
Applicable age 3-8 years old power supply modes ChargeType
The limit load 40kg the specifications for battery
charger 12V800MA 12V1000MA
running speed 2-6Km/hr Normal charging time 8-12 hours
Fuse Size 15A(18A) Regular life of battery About 280 times

2

Four Motors Rear Wheel x4
Two Motors Rear Wheel x2
Tow Hook Tail Lights
123
4
7 8 9
56
3
2.4G 27M
4mm Belt Pad
Self-tapping Screws
Remote Control
Charger
Car Body
Two Motors Front Wheel x2
Parts List

4
1
4
3
3
3
3
7
5
7
6
6
Exploded View

5
Assembly Process Diagram
1.As shown first connect the power plug with fence,
then insert the lamp fence fence upper part of the hole in the
direction shown;
● Before using, the vehicle must be assembled by an adult. It takes about 10 minutes to
assemble the product.
● Small parts are likely to be swallowed into throat, and prohibit children from touching
and playing!
● Before installation, please check the number of all parts, and packaging bags of product
should be disposed. Prohibit children from playing with it, which may result in the danger
of suffocation!

6
4
Assembly Process Diagram
2.As shown first connect the power plug with fence, then insert
the lamp fence fence upper part of the hole in the direction shown;
3.As shown the mirror were inserted into the mirror in front of
the hole on the left and right doors, each with a 4mm tape pad
self-tapping screws and tighten up separately from the bottom of
the hole mirror self-tapping screws, the mirror is fully instal
led to the door (Note: one on the left and another one is on right);
4.Tow hook assembly in the direction to Front bumper frame snap groove.
5. At last remove the seat cushion of the four screws, connect the
battery red cable, then by four self-tapping screws to install
the cushion.
Pull-out
Restoration
Restoration
Pulley frame
component
Shake
handshandle
Pull-out

7
USB
SD
MP3
V
V
MODE
DISPLAY SCREEN
1 2 3 4
（TF)
Swing/movement
(with swing function)
Move seat handle
(Under the seat)

8
USB Player
(Standard is
with Mp3 input
and voice
adjustment)
Forward/backward
Start Button
Foot Switch
High speed/low
speed
Light switch
Main Function：
When with electronic steering,
automatic return of function.
Remark:
a. The vehicle can be configured simple drag
b. The vehicle can be equipped with swing function
c. The vehicle can be equipped with light-emitting function wheel
Steer wheel button function

9

10