Lean Cars KP-6699 User manual

Child electric vehicle installation instructions
Instructions for use
1, slow speed should be promptly charged, the time is 8-15 hours, not
more than 18 hours.
2, the charge must be charged in the adult under the charge, charging
the charger and the battery There is a slight temperature phenomenon,
is a normal condition
3, the car must be carried out by adults, do not let children touch, small
objects have swallowing risk 1
4, after the completion of the installation of packaging plastic bags,
please properly collection, do not let the children play, suffocated
Danger 1
5, the battery positive and negative is strictly prohibited short. There is
a risk of burns and fire
6. Waste 1 day battery should be handed over to the recycling company
for processing.
7, do not operate before and after the switch, or damage to the device,
to change, the first release of the foot
After the switch is turned on, the switch is advanced
8, in the non-riding state, please forward, stop, back switch set "empty"
file. Turn off the electricity Source switch (Note: this switch can only
control the drive part)
9, in order to ensure electrical safety The maximum current of the car
fuse 5A can not arbitrarily change the parameters
10. Child in use, prohibit adults or older children from behind to push
forward, has damaged the motor.
11, the maximum load of 50KG, such as overload or road congestion,
etc., the car built-in electronic insurance, Will automatically stop The
car is automatically restored after 5-10 seconds
12, to regular maintenance of the vehicle, found to be damaged when
the use of damage, until the repair in use,So as to avoid danger to the
child.
1, this product is only suitable for sale in the Chinese market
2, the instructions used in this manual is to explain the operation of the product
release and productsStructure, when the installation diagram and the physical
existence of a small difference, please prevail in kind.
3, the product and the outer box are affixed with a registered trademark of the
product, if fake please timely
4, inform the company, consumption can be reported to the business sector or
consumer association complaints
5, the safety of the vehicle for a period of 2 years
product description

Parts:
Steering wheel 1 Block board 1 One windshield board Remote control 1
Standby remote
control 1 Rear wheel 2 Front wheel 2 Big wheel 4
Small wheel 4 After the tail lights 2 Charger 1 Backlight bracket 1
Wrench one Body 1
installation steps:
Install the seat plate: first connect the wires on the body, red to red, black to black,
and then screwdriver Remove the left and right screws of the seat, and then the seat
plate behind the card slot on the car card slot card, the most After the screw with a
screw can be fixed.
After the installation of the tail: the first rear taillight in the rear light bracket, and then
install the rear tail at the rear of the rear of the car on both sides of the card slot, the
card can be.
Install the steering wheel: first screw off, and then connect the steering wheel
connector on the body connector, and then press the steering wheel down, with a
screw can be fixed.
Install the front wheel: first remove the nut and gasket on the axle,and then the front
wheel hole at the axle through, padOn the card, with a wrench to tighten the nut,
followed by a large card, small wheel can be
Install the windshield plate: the wind deflector at
the front of the body card slot, forced down to force.
Install the rear wheels: first remove the nuts and gaskets on the axle, and then align
the rear wheels into the axle, pad the pad, tighten the nut with a wrench, and then
click on the large and small wheels.