LEGRAND Wiremold TableSource User manual

TableSource™
Work Surface Modules
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 42073R1 – Updated December 2011
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before be innin .
NOTE: Use No. 8 (5/16" [7.9mm] head size) flat head fastener or equivalent
to secure mountin clip onto table surface (top or bottom).
INSTALLATION:
REMOVAL:

WIREMOLD
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1 800 621 0049 • FAX [phone] • Outside U.S.: 860 233 6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1 800 723 5175 • FAX [phone]
42073R1 1211
© Copyright 2011 Legrand/Wiremold All Rights Reserved
Foam
Remove
Adhesive
Coverin
ASSEMBLY:
INSTALLATION: REMOVAL: