LEGRAND HPM CFREMOTEH User manual

Ceiling Fan Infrared Remote Control Kit
Cat. No: CFREMOTEH,CFREMOTEJ
Instruction Manual
PLEASE READ ALL INSTRUCTIONS CAREFULLY. RETAIN FOR FUTURE REFERENCE.
INSTALLATION MUST BE CARRIED OUT BY A LICENSED ELECTRICAL CONTRACTOR.
1. The CFREMOTE range is compatible with HPM’s CF Series of
Ceiling Sweep Fans only.
2. CFREMOTEH is compatible with HPM Hang-Sure fans only.
CFREMOTEJ is compatible with HPM J-Hook fans only.
3. The infrared transmitter has a maximum working range of 10
metres (unobstructed).
4. The remote control cannot be used in combination with a wall
mounted fan controller.
5. The same remote control can be used to control several of
HPM CF ceiling fans fitted with the receiver module.
6. Dimming function works with dimmable halogen,
incandescent and some LED lamps only. Compatibility with
non-dimmable or CFL lamps is not guaranteed. Dimming
levels will vary depending on the dimmable lamp.
7. Fan can be directly connected using the compatible cable
connectors on the Remote Control Kit.
Hand-held Remote Mode Operation
Timer Allows the fan to run
for a further 2/4/6
hours of operation
before switching off
automatically.
Does not affect the
light output.
Fan
Speed
3 fan speeds can be
selected.
FAN OFF will switch
off fan when in
Timer mode.
Light 3 light levels can be
selected. Requires a
dimmable lamp to be
fitted in lighting kit.
Important considerations
Hang-sure Bracket
Hang the fan on the bracket.
Ensure bracket guide pin is
fitted into slot on ball joint
and that all wires are clear
of the ball joint.
J-Hook Bracket
Hang the fan on the J-Hook.
Ensure that all wires are clear of the rubber roller.
Position the receiver in the cowling.
Insert the receiver into the
Hang-sure bracket.
Place the sensors on edge of
cowling at opposite ends.
Tighten the 2 screws to the
downrod.
Place the sensors on edge of
cowling at opposite ends.
Fix the cowling to the bracket
by tightening the 2 screws.
2Mounting
CFREMOTEH CFREMOTEJ
1
Specifications
Input voltage 230 - 240 V a.c. 50 Hz
Standby Power < 0.5 W
Output Rating Fan motor 65 VA max.
Light 120 VA max.
Light Dimmer Trailing Edge Dimmer
Box Contents
■Receiver
■ Wall mount bracket
■ Remote control (with CR2025 lithium battery included)
Safety screw must be installed after replacing battery.
Fig. 1
2H
6H4H
Timer
2, 4 & 6 hour
All ON/OFF
Fan Speed
Low, med & high
Light
Low, med & high
Wall-mount
bracket
included
2H
6H4H
!
FOR CFREMOTEH

Remote
control
receiver
Neutral
Active
1. Isolate 240V mains power to circuit.
2. Connect the plug (mains terminal block) to the socket
connector from the fan.
3. Connect supply wiring to mains terminal block provided. When
installing the CFREMOTEH, ensure Hang-sure mounting
bracket is earthed as per sweep fan instruction sheet.
4. Reconnect power to circuit.
■This product contains a coin Lithium battery.
■Ensure the device’s battery compartment is secured with
screw provided (refer to battery lid screw, Fig. 1 on front
page). Do not use if compartment is not secure.
■ Dispose used button/coin batteries immediately by placing sticky
tape around both sides of the battery and dispose of it immediately
in an outside bin, out of reach of children, or recycle safely.
■Flat batteries can still be dangerous. Dispose used batteries
safely. Swallowing may lead to serious injury or death.
■If you suspect a child has swallowed or inserted a button
battery, call the 24 Hour Poisons information Center on 131126
or expert advice.
■Flat batteries can still be dangerous. Dispose of usedbatteries
safely. Swallowing may lead to serious injury or death.
■ A Lithium battery can cause severe or fatal injuries in 2 hours
or less if it is swallowed or placed inside any part of the body.
3 6
4
5
Wiring
Battery Warnings
Warranty
Legrand warrants this product for a period of 2 years from the date of purchase.
These goods come with guarantees that cannot be excluded under the Australian
and New Zealand Consumer Laws. You are entitled to a replacement or a refund for
a major failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
See the Warranty card enclosed with this product for further details.
Customer Service
For all Customer Service and Technical Support
please call Monday to Friday during business hours.
LE12801AB 01/2022
Product Notes
1. This product must be installed by a licensed electrician and
used as per these instructions.
2. During installation a switch disconnection should be
incorporated in the supply circuit.
3. This product contains no serviceable parts and no attempt
should be made to repair this product. If the product is faulty
it should be discarded.
4. This product has been designed to operate in ambient
temperatures between 5°C to 40°C.
5. This product is not intended to be exposed to direct weathering.
It is not suitable for installation in hazardous and/or corrosive
areas.
6. This product is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of this
product by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
7. This product has been designed to operate on a nominal supply
voltage of 230 - 240 V a.c. 50 Hz.
8. Electrical installations periodically receive transient over
voltages. This product has been designed to minimise the
effect of such voltages on connected equipment. It may not
give full protection for extreme over voltage transients such as
those resulting from a close lighting strike.
9. After installation this product must be tested as required by the
appropriate government and/or statutory regulations.
10. Keep away from children.
11. This product utilises intellectual property in the form of
registered designs, trademarks, and/or patents. Such
intellectual property remains the property of Legrand in all
cases.
12. Legrand reserves the right to modify the specification of this
product at any time.
Legrand Australia
1300 369 777
www.hpm.com.au
Legrand New Zealand
0800 476 009
www.hpm.co.nz
ABN: 31 000 102 661
Paper
1. Fix bracket to wall in a suitable location indoors.
2. Open the battery compartment in the remote and remove
protective sleeve from battery.
3. Test fan operation.
Wall mounting of Remote Control
THIS PRODUCT CONTAINS A COIN BATTERY
If swallowed, a lithium coin battery can
cause severe or fatal injuries within 2 hours.
Keep batteries out of reach of children.
If you think batteries may have been
swallowed or placed inside any part of the
body, seek medical attention immediately.
!
WARNING