LEGRAND 0 626 00 User manual

1
LE05156AE
Interface + configuration software
0 626 00
Important:
According to the European directive 91/157/EEC dated 18 March 1991, the batteries in this interface, which contain cadmium, may be dangerous for
the environment.
Technical characteristics:
• Power supply : 230V~50Hz
• Power consumption : 5 W 45 mA
• Battery : 9 V/110 mAh NiCd/NiMH
• Fuse protection : BUS 0.5 A F 250 V~(5 x 20)
• Connection : Mains, 2 terminals 1 x 1.5 mm²
• Cable sizes : - Remote controls, 2 terminals 1 x 1.5 mm²
- RS 232, 5 terminals 1 x 1.5 mm²
- RS 485, 2 terminals 1 x 1.5 mm²
- Fault relays, 6 terminals 1 x 1.5 mm²
- RJ 45 for connection to IP network
- Mini USB for direct connection to PC (max 1.5 m)
• Case insulation : Class II
• Operating temperature : + 5 °C to + 40 °C
• Storage temperature : - 10 °C to + 60 °C
• Dimensions : W 178.2 mm x H 87.1 mm
10 modules
To use this interface, you must first configure it with the configuration programme delivered on the USB-stick and using guide LE05022XX.
1Fault relay 1 connection terminals
2Fault relay 2 connection terminals
3Fault relay indicator
4USB socket
5Mains supply terminals
6Connection terminals for RS485 (2 conductors)
Connection terminals for RS232 (5 conductors)
Battery charge indicator
9Connection terminals for exterior control box catalogue no.: 0 039 00
BUS connection terminals
BUS presence indicator
Emergency lighting unit on/off buttons
Unit MAC address
RJ 45 connector for IP network
IP network presence indicator
Unit address selector
BUS protection fuse
Reset button
Description
Network
Reset
626 00
1 2
BUS
RS 485
1 23
 
       


2
System presentation
Rules of connecting
The interface Cat. No. 0 626 00 can monitor up to 1023 addressable emergency lighting units with 4 repeaters Cat. No. 0 626 03.
The maximum length of a line is 700 metres, above this you should add a repeater, Cat. No. 0 626 03.
The interface and each of its repeaters may be connected to a maximum of 250 addressable emergency lighting units.
Cable to be used for power supply and BUS connections for addressable emergency lighting units: U 1000 R2V 5G 1.5 mm2.
The total maximum length of a line is 2000 m (for star configurations). Beyond this distance add a repeater Cat. No. 0 626 03.
Star wiring example
Network
Reset
626 00
1 2
BUS
RS 485
Interface
Cat. No. 0 626 00
Max. length of a line of units: 700 m.
Above this, place a repeater in series with the following units
(max. BUS length 2000 m).
1023 units max.
250 units max.,
directly connected
to an interface.
Above this, use a repeater
Interface
MCB
Repeater
MCB
Repeater
Cat. No.
0 626 03
Example of series wiring, maximum 4 repeaters in series
10 A
MCB
230 V~ mains
Interface
Cat. No.
0 626 00
Repeater
Cat. No. 0 626 03
OUTBUS IN OUTIN
Max. length of a line of units: 700 m.
Above this, place a repeater in series with the following units
Max. length of a line of units: 700 m.
Above this, place a repeater in series with the following units
Repeater
Cat. No. 0 626 03
Safety instructions
This product should be installed in compliance with installation rules, preferably by a qualified electrician. Incorrect installation and/or incorrect use can lead to risk of electric
shock or fire. Before carrying out the installation, read the instructions and take account of the product’s specific mounting location.
Do not open up, dismantle, alter or modify the device except where specifically required to do so by the instructions. All Legrand products must be opened and repaired
exclusively by personnel trained and approved by Legrand. Any unauthorised opening or repair completely cancels all liabilities and the rights to replacement and guarantees.
Use only Legrand brand accessories.