Leica DISTO D810 touch Use and care manual

Update Firmware V 1705
Leica DISTOTM D810 touch 1
Precondition: You need Leica DISTOTM D810 touch, USB cable and a Windows PC.
1. Download program
from webpage:
http://ptd.leica-
geosystems.com/en/Softw
are-Leica-DISTO-D810-
touch_104999.htm
2. Execute the update
program in order to install
and follow instructions.
3. Start update program
on PC.
4. Press button ON DIST
to switch on device.
5. Press six buttons in the
same order as shown in
picture.

Update Firmware V 1705
Leica DISTOTM D810 touch 2
6. Check firmware version:
if it is less than 1705,
proceed with step 7. If it is
1705, you do not need to
continue, as you already
have the new version
installed on your device.
7. Press key Down
navigation to select entry
USB RNDIS.
8. Press selection key
below green tackle to
confirm.
9. Press button C/OFF for
two seconds to switch off
device.

Update Firmware V 1705
Leica DISTOTM D810 touch 3
10. Connect device to
laptop/PC via USB cable.
11. Device switches on
automatically. Battery icon
appears on screen.
12. Click button start to
start installation process.
13. A load beam appears
on screen. Update process
is running for about 10
minutes.
Note! Do not disconnect
device from laptop/PC
during update process! An
Error Message 5056 may
shortly appear on DISTO™
display during installation.
14. If the installation has
been successful the
message “success” and a
green tackle appears on
screen.