7Rugby 200-3.2.1en
Buttons
3 Rotation Speed Button
Used to change the speed of
the rotating head from
stationary to fast rotation. The
head speed increases each time the
button is pressed. Speed selections
are 0, 1, 2, 5 and 10 rps.
4 Scan Button
Allows the operator to select
anareafor the rotating head to
scan instead of completing a
full 360° revolution. Scan selections
are approximately 10°, 45°, 90°, and
180°. The scan area increases each
time the button is pressed. If the head
is rotating and the Scan Sweep Button
is pressed, the head will begin to scan
in the area last selected.
5 Rotation Direction Buttons
Allows the operator to position
the rotating head by moving it
clockwise or counterclockwise
when it is stopped or is
scanning. Pressing the button
will move the head in small
increments. Pressing and holding the
button move the head more quickly.
6 Beam Down Button
Positions the beam directly
belowthe aperturefor laydown
setups.
7 H.I. Button
Also called Height of
Instrument or Elevation Alert,
when activated will reduce the
amount of self-leveling range to
prevent elevation errors as a result of
movement of the tripod or other
sudden movement.
• The Rugby must reach a
completely level position and
remain undisturbed for 30 seconds
before the Alert becomes active.
• The LED at the side of the H.I.
Button will turn on solid when
elevation alert is turned on. It will
flash rapidly (5 Hz) when the laser
has moved and an alert condition
exists.
• Press the H.I. or Automatic/Manual
Button to stop the alert.
• Check for the cause of the alert,
adjust the height of the instrument,
allow the unit to relevel.
• Press the H.I. Button again to reset
the alert.
