Lightmybricks Fire Brigade User manual

Light My Bricks : Fire Brigade LED Lighting Kit
Here is the instructions document for the LEGO Fire Brigade LED lighting kit. Please read
and follow the steps carefully to ensure this lighting kit is installed properly.
Package contents:
 1x Lamp Post with 30cm Bit Light installed
 4x White Bit Lights 30cm
 4x White Bit Lights 15cm
 2x White Flashing Bit Lights 15cm
 2x Red Flashing Bit Lights 30cm
 5x LED Strip Lights
 4x 15cm Connecting Cables
 1x 30cm Connecting Cable
 5x Adhesive Squares
 1x 12-port Expansion Board
 1x 8-port Expansion Board
 1x AA Battery Pack (Requires 3x AA Batteries)
 1x Flat Battery Pack (Requires 2x CR2032 Batteries)
Extra LEGO Pieces
 2x LEGO Trans Red 1×1 round bricks
 2x LEGO Light Grey 1L bar with mechanical claw clip
 4x LEGO Plates 1×6 for mounting Strip Lights

Important things to note:
Laying cables in between and underneath bricks
Cables can fit in between and underneath LEGO® bricks, plates, and tiles providing they
are laid correctly between the LEGO® studs. Do NOT forcefully join LEGO® together
around cables; instead ensure they are laying comfortably in between each stud.

CAUTION: Forcing LEGO® to connect over a cable can result in damaging the cable
and light.
Connecting cable connectors to Strip Lights
Take extra care when inserting connectors to ports on the Strip Lights. Connectors can be
inserted only one way. With the Strip Light facing up, ensure the side of the connector
with the wires exposed is facing down. If a plug won’t fit easily into a port connector, don’t
force it. Doing so will damage the plug and the connector.

Connecting cable connectors to Expansion Boards
Take extra care when inserting connectors to ports of Expansion Boards. Connectors can
be inserted only one way. With the expansion board facing up, look for the soldered “=”
symbol on the left side of the port. The connector side with the wires exposed should be
facing toward the soldered “=” symbol as you insert into the port. If a plug won’t fit easily
into a port connector, do not force it.

Incorrectly inserting the connector can result in bent pins inside the port or
possible overheating of the expansion board when connected.
Installing Bit Lights under LEGO® bricks and plates.
When installing Bit Lights under LEGO® pieces, ensure they are placed the correct way
up (Yellow LED component exposed). You can either place them directly on top of
LEGO® studs or in between.

OK, Let’s Begin!
Instructions for installing this kit

This section will guide you to install light to the fire truck first.
1) Start by removing the following pieces to allow us to remove one of the headlight
sections from the front.

Remove the trans yellow round plate and then take one White 15cm Bit Light and thread
the connector side through the front hole of the red brick as per below.