Lincat Lunx 400 LPO Guide

IS313 ECN3016 Page 1
INSTALLATION AND USER INSTRUCTIONS
ELECTRIC PIZZA OVEN
MODEL LPO
Dear Customer,
Thank you for purchasing this Lincat Product.
This is just one of over 400 different items of catering equipment available from our range which is constantly being
extended and improved. Details are available from your local distributor or direct from us.
Used for the purposes for which it is intended, and with careful maintenance as outlined in this user Guide, your
Lincat product will give years of trouble free use.
IMPORTANT INFORMATION
Please read all of the safety and operating instructions carefully before using this product. Please pay
particular attention to all sections of this User Guide that carry warning symbols and notices.
WARNING!
This is a Warning symbol. This symbol is used throughout the user guide whenever there is a risk
of personal injury. Ensure that these warnings are read and understood at all times.
CAUTION!
This is a Caution symbol. This symbol is used throughout the User Guide whenever there is a risk
damaging your Lincat product. Ensure that these warnings are read and understood at all times.

IS313 ECN3016 Page 2
SAFETY INSTRUCTIONS
TECHNICAL SPECIFICATION
INSTALLATION
PACK CONTENTS
WARNING!
Basic safety precautions, including the following, should be followed to reduce the risk of personal injury.
Make sure you have read all of these instructions before switching on the unit. Keep this User Guide in
a safe place for future reference for you and your staff.
GENERAL
Do not clean the unit with a water jet.
Do not try to modify this product.
In the interest of hygiene, you should clean the product after unpacking and ensure all plastic coatings are
removed before use.
Ensure that the electrical supply cable is not damaged. If the supply cable is damaged it should be replaced
by Lincat Ltd or other suitably qualified persons, in order to avoid a hazard.
Disconnect the unit from the electric supply before servicing or undertaking any electrical maintenance.
This unit must be earthed.
Electric pizza oven (with electrical supply cable and
13 amp plug)
Crumb tray
Drawer with chrome rack
User instructions
Guarantee card
Ensure that the unit is installed on a sound, level work surface, which is heat resistant e.g. stainless
steel or formica. Inform your personnel that the external surfaces and base will become hot
For safety regulations, the plug must always be accessible .
CONNECTING TO THE ELECTRICITY SUPPLY
Ensure that the voltage of your electricity supply corresponds to the serial plate details. The product is
supplied with a 13 amp plug. To replace the plug, follow these instructions:
•green and yellow wire to 'E' or (Earth)
•blue wire to 'N' (Neutral)
•brown wire to 'L' (Live)
Model LPO
Width mm 543
Depth mm 499
Height mm 203
Power Rating watts 1500
Weight (net) kg 18.5

IS313 ECN3016 Page 3
OPERA
TING INSTRUCTIONS
CLEANING AND MAINTENANCE
1
2
43
Fig 1
1 Green neon
2 Timer
3 Re-set button (Safety thermostat)
4 Control knob
Connect the unit to the electricity supply. The green neon will light up. Turn the control knob to set the desired
temperature. The amber neon will also light up. When the oven has heated up to the set temperature, the amber
neon will extinguish.
The timer is not connected to the oven control. To turn the oven off, turn the control knob to ‘0’.
To check contents, pull drawer carefully straight out, keeping level until it locks into place. To remove drawer
completely pull forwards whilst tilting downwards.
Safety (High Limit) Thermostat
This unit is fitted with two thermostats. One controls the temperature inside the oven; the other prevents the
temperature from reaching a dangerous level if there is a fault with the unit or power supply.
Ensure that the control thermostat is not damaged during use and cleaning. If the green neon lights up but the
element does not heat up the safety thermostat may need to be re-set.
Re-set button (safety thermostat)
Push the re-set button (3).
Note: The re-set button cannot be activated until the oven has cooled sufficiently.
CLEANING
Disconnect the unit from the electricity supply and allow to cool before starting to clean. Use a mild
detergent in hot water and a soft cloth. Do not use abrasive creams or scourers.
MAINTENANCE
Regular cleaning of the unit is recommended.
Regular maintenance is not required.

IS313 ECN3016 Page 4
GUARANTEE
SERVICE INFORMATION
For help regarding the installation, maintenance and use of your Lincat equipment, please contact our service
department:
01522 875520
All service work, other than routine cleaning should be carried out by one of our authorised service agents. We
cannot accept responsibility for work carried out by other persons.
To ensure your service enquiry is handled as efficiently as possible, you need to have the following details available :
•Brief details of problem
•Product code, type number and serial number of unit (both on serial plate)
Lincat reserve the right to carry out any work under warranty during normal working hours, ie Monday to Friday,
08:30 a.m. – 17:30 p.m.
This unit carries a comprehensive UK twelve-month warranty. The guarantee is in addition to, and does not
diminish your statutory or legal rights.
The guarantee does not cover:
•Accidental damage, misuse (or use not in accordance with the instructions in this User Guide), or
consumable items.
•Damage due to incorrect installation, modification or unauthorised service work.
•The manufacturer disclaims any liability for incidental, or consequential damages.