Linkskey LKS-SG16R User manual

LKS
-
SG16R / SG24R
Rev.B
1
Introduction
A
The LKS-SG16R / LKS-SG24R 10BASE-T/100BASE-TX/1000BASE-T
Switches which are high-performance Gigabit Ethernet Switches designed
for the network core. It provides 16/24 10BASE-T/100BASE-TX/1000BASE-T
ports that can significantly improve the performance of your network’s
backbone,and deliver the throughput needed to support a broad range of
advanced network applications. With LKS-SG16R / LKS-SG24R high
performance band-width , it provides the quickest solution to meeting the
growing demands on your network＇s limited resources.
Features
B
z16/24 Port 10/100/1000Mbps Auto-Negotiation andAuto-MDI/MDI-X
Gigabit Ethernet Switch
zComplies with the IEEE 802.3 10Base-T Ethernet,IEEE 802.3u
100Base-TX Fast Ethernet and IEEE 802.3ab 1000Base-T Gigabit
Ethernet standards
zIEEE 802.3x Flow Control for Full-duplex and Back Pressure for
Half-duplex
zSupport Full/Half duplex transfer mode for 10/100Mbps
zSupport Full duplex transfer mode for 1000Mbps
zSupport Store-and-Forward architecture and performs Forwarding

LKS
-
SG16R / SG24R
Rev.B
2
and Filtering
zFull Wire-Speed Non-Blocking Reception and Transmission
zExtensive front-panel diagnostic LEDs
zRack-mountable kit to fit 19” rackmount shelf
Package Contents
C
zRackmount Kit.
zUser guide.
zPower cord.
zLKS-SG16R/LKS-SG24R Gigabit Ethernet Switch
Hardware Introduction
D
4.1 Front Panel
The unit front panel provides a simple interface monitoring the
Switch. See the chart in section 4.2 for the status of each LED
denotes..

LKS
-
SG16R / SG24R
Rev.B
3
4.2 LED Displays
4.3 Rear Panel
The rear panel of the LKS-SG16R / SG24R Gigabit Ethernet Switch
indicates an AC inlet, which accepts 100-240VAC 50-60Hz power input.

LKS
-
SG16R / SG24R
Rev.B
4

LKS
-
SG16R / SG24R
Rev.B
5
FCC Warning
This ations
e
equipment has been tested and found to comply with the regul
for a Class B digital device, pursuant to Part 15 of the FCC Rules. Thes
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with this
user’s guide, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the
interference at his own expense.
zReorient the receiving antenna.
zIncrease the separation between the equipment and receiver.
zConnect the equipment into an outlet on a circuit in a different room
that to which the receiver is connected.
zConsult the dealer or an experienced radio/TV technician for help.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.

1