Linkskey LKS-SG5P User manual

LKS-SG5P / LKS-SG8P
Introduction
LKS-SG5P / LKS-SG8P is 5/8-port 10/100/1000Mbps unmanaged
Gigabit Ethernet Switch. The Switch provides 5/8 x 10/100/1000Mbps
Auto-Negotiation RJ45 ports. All RJ45 ports support the Auto-MDI/MDI-X
function. Every port can work as uplink port or common port. LKS-SG5P /
LKS-SG8P provides a cost-effective, high performance, non-disruptive,
smooth evolution into gigabit solutions. The Switch delivers superior
performance with improving workgroup, network bandwidth, increasing
network node, providing greater flexibility, installation convenience. It is the
best choice for increasing your speed.
Features
Link-On and Cable Length Power Saving
Link-Down Power Saving
Energy-Efficient Ethernet (EEE), IEEE 802.3az
Complies with IEEE Half and Full-Duplex standards
Non-blocking wire-speed reception and transmission and
non-head-of-line-blocking forwarding
Supports IEEE802.3x full/half duplex flow control and back pressure
Auto-Negotiation RJ45 ports supporting Auto-MDI/MDI-X
Supports MAC address auto-learning and auto-aging
Compact design for desktop or wall mounting
Plug-and-play enabled for easy setup and configuration
B
A

2
LKS-SG5P / LKS-SG8P
Hardware Installation
C
Connect an Ethernet network cable from
the computer to an available Ethernet port
on the LKS-SG5P /LKS-SG8P
Connect the AC Power Adapter to the
LKS-SG5P / LKS-SG8P, and then to a power outlet.

3
LKS-SG5P / LKS-SG8P
LED
D
Power LED
Green：Power is on
Not Illuminated：Power is off
Link/Act LED
Green(Solid)：indicate that the port is operating at 10 or 100Mbps.
Orange(Solid)：indicate that the port is operating at 1000Mbps.
Blinking : indicate that there is activity of data occurring at the port.
Not illuminated：indicate that the link is not established at the port.

4
LKS-SG5P / LKS-SG8P
Technical Specifications
Standards and Protocol IEEE 802.3, IEEE 802.3u, IEEE 802.3ab,
IEEE 802.3az, IEEE 802.3x
Transfer Method Store and Forward
Number of Ports 5/8 x 10/100/1000Mbps Auto-Negotiation ports
Network Media
Ethernet：Cat. 3, 4, 5 up to 100m
Fast Ethernet：Cat. 5, 5e up to 100m
Gigabit Ethernet：Cat. 5, 5e, 6 up to 100m
MAC Address LKS-SG5P：2K
LKS-SG8P：8K
Switching Capacity LKS-SG5P：10G
LKS-SG8P：16G
Frame Filtering and
Forward Rate
10Mbps：14880pps
100Mbps：148800pps
1000Mbps：1488000pps
LED
Indicator
Link/Act 10/100Mbps：Green
1000Mbps：Orange
Power Green
Dimension (L × W × H) 156 (L) X 106 (w) X 31(H) mm
Environment
Operating Temperature：0°C ~40°C (32°~104°F)
Storage Temperature：-40°C ~70°C (-40°~158°F)
Operating Humidity：10%~90% RH, Non-condensing
Storage Humidity：5%~90% RH, Non-condensing

5
LKS-SG5P / LKS-SG8P
FCC Warning
This equipment has been tested and found to comply with the regulations
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with this
user’s guide, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the
interference at his own expense.
Reorient the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit in a different room
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.