Little Folks Furniture Fargo SBD002 User manual

PLEASE READ CAREFULLY & KEEP FOR FUTURE REFERENCE
Code: SBD002
Fargo Bed

Treated properly it should be a faithful servant for years - and we hope you get the same
amount of pleasure from it. Before you do
lplease take a few minutes to read these instructions
lwe suggest you carefully unpack everything, lay it out on a clean, flat floor and identify
everything on the parts list in these instructions. Do not throw away any packaging until
you are sure you have all the parts.
If you have any problems assembling the product please call our customer services on
01985 300588 and we will try and help. If for any reason you wish to return the product, you
must disassemble the product and pack in the original packaging.
Taking care of your product
Your furniture should require no more than a regular dust off with a soft cloth. If the furniture is not
painted then a superior wood polish can be used - but never use polishes containing silicone.
If necessary it can be cleaned with a damp cloth with a mild detergent solution - and then dried with a
lint-free cloth. Never clean with abrasives or chemical cleaners.
Direct sunlight or heat from a radiator can stain, discolour warp or crack furniture.
We know furniture can be heavy but try not to drag furniture across the floor as this can damage it.
Thank you for buying a
PRODUCT SAFETY
piece of furniture
If you have any problems please do contact us for help on e mail
[email protected] or phone our
CUSTOMER SERVICES 01985 300588
The recommended size of the mattress is 191cm x 90cm (6`3” x 3`0)
Periodically check all fittings to ensure that none have come loose.
Keep away from direct sources of heat, such as electric, gas or coal fires.
Do not allow children to Climb on the furniture.
Using this furniture other than for its intended purpose could cause damage to the
structure or serious injury to your child.
The Bed should not be used if any structural part is broken or missing.
If you can manage it, please try to persuade your children not to bounce on the bed.
Warning: The child`s bed should not be placed too close to other furniture or windows,
blind cords, curtain pulls or other strings or cords, and should be placed either tight to
any wall or have a gap of 300mm between the wall and the side of the bed.

2x Mattress Rails
1x Mattress Base
30 x Screws
Fittings
Tools Req
Screwdriver
1x Head End 1x Foot End
Spanner
8 x Dowels
4 x nuts, 4 x washers, 4 x spring washers & 4 x treaded bars
Parts

Fitting the bed legs.
4 threaded bars and 8 wooden dowels
Insert and rotate each threaded bar into the centre hole on each bed leg. Now insert the
wooden dowels into the two holes either side.
Fix the base
30 x Wood screws
Lift the slatted base onto the
bed, slide out and screw down.
Note: Both bed end slats should
be tightly fitted at each end.
Making the bed. (Two people required)
Slide each mattress rail onto the threaded bar and
wooden dowels that you have fitted in the legs. Carefully
slide the lunar washer onto the threaded bar as it passes
through the large hole in each mattress rail. As this bar
passes through the lunar washer slip on the spring washer
then the normal washer and then finally the nut. Push the
bed frame together. Rotate the nut using the spanner
provided and tighten the bed frame.
X 30