Logitech CRAYON User manual

PRODUCT SETUP
1. Press the power button for 1 second. The LED will turn green —ready to go.
2. If LED turns red, charge the pen before use.
LED Behavior Logitech Crayon status
Fade in green Power on
Fade out green Power o
Solid green Fully charged
Breathing green Charging
Blinking red Battery level is critical (less than 5%)
Red when user presses button Battery level is low (less than 10%)
Green when user presses button Battery level is good
Yellow Firmware update
KNOW YOUR PRODUCT
Lightning port
Cap Power button Pen tube Tip cover
TipLED
LOGITECH CRAYON
Setup guide
Make sure iPad iOS is updated
to version 11.4 or above

Find the removal tool. Align the tool with the two
holes in the pen tube.
Squeeze the tool and pull o
the tip cover.
CHARGING
1. Flip open the cap.
2. Insert lightning cable.
3. Connect cable to a power adapter
or any computer to charge.
4. LED will turn green.
REPLACING THE TIP COVER
1
Make sure tip is tightened
before replacing tip cover.
4
Insert new tip cover into pen
until you hear a click.
5
23

Find the removal tool. Align the tool with the two
holes in the pen tube.
Squeeze the tool and pull o
the tip cover.
REPLACING THE TIP
1
Twist the tip counter-clockwise
to remove.
4
Insert new tip and twist
clockwise to tighten securely.
5
Insert new tip cover into pen
until you hear a click.
6
23
Open the cap. Push the cap back and slowly
pull the cap ring o of the
pen tube.
Align new cap to the pen tube.
REPLACING THE CAP
1
Push the cap ring into position,
making sure the notch ts
into slot.
4
23