Louvolite R1700 Manual instruction

MOTOR TORQUE/SPEED: 0.3NM/34RPM
• Motor is combined with a wired switch and powered by a battery wand.
• The side of the motor mount with the adjuster screws should face you.
• Please replace batteries as required (6 months)
SET-UP LOWER LIMIT
• Rotate red screw anti-clockwise to raise the lower limit
• Rotate red screw clockwise to lower the lower limit
SET-UP UPPER LIMIT
• Rotate white screw clockwise to raise the upper limit
• Rotate white screw anti-clockwise to lower the upper
limit
Up Button
Down Button
SET-UP AND OPERATION
SETTING THE LIMIT
R1700 REMOTE CONTROL
programming instuctions

1. Check the motor direction by pressing UP or DOWN on the switch.
2. If correct then proceed to set-up lower limit, if incorrect change the motor direction as below
CHANGE MOTOR DIRECTION
1.
Press and hold UP and DOWN button together on the wand
control for 6 seconds and the motor will jog the blind to
indicate the direction has changed.
TO RAISE THE BLIND
1. Press UP button on the wand control to raise the blind .
2. Press the UP button on the wand control to stop the blind
at desired position.
PLEASE NOTE:
If at any time the motor defaults
to jog mode follow these steps to revert to normal setting.
TO LOWER THE BLIND
1. Press DOWN button on the wand control to lower the blind.
2. Press the DOWN button on the wand and control to stop
the blind at desired position.
JOG MODE
1. Press and hold UP and DOWN button together on the wand
control for 10 seconds and the motor will jog twice.
OPERATION
SET-UP AND OPERATION
SETTING THE LIMIT
R1700 REMOTE CONTROL
Oct 2017