Louvolite Perfect Fit User manual

Louvolite Customer Services Tel: [phone] Email: [email protected]
www.louvolite.com
Perfect Fit®Roller Blind
Fitting Instructions
CHILD SAFE

Fitting Perfect Fit®
Attach base frame to each
side frame using 2 corner
joints, lining up with the
correct punch hole positions
as shown opposite.
Tighten the 4 screws on each
of the corner joints.
Securing Bottom Bar
Attach end caps and x one side in position at a slight angle then place the
opposite side into position. Please ensure that the bottom bar sits behind the
grooving.
Slide the top section into the rest of
the frame, attach the end caps and
then tighten the screws on each joint.
65mm
85mm
85mm
65mm
Carefully unwrap and place on a
clean surface.

Fitting Perfect Fit®
To ensure all brackets are in the correct position for tting (85mm from beading)
use a credit card in the corner of the window to locate the bracket position.
For ease of insertion, use a lubricant in the form of washing up liquid on the base
of each bracket.
Line up the bracket with the base or top of the credit card (depending on which
corner of the window you are working) and t the bracket by pushing it between
the glass and the rubber seal of the window.
Repeat for all 4 corners of the window, and intermediate brackets (if required)
then clean excess lubricant prior to tting the frame.
Line up bracket
with edge of card

Fitting the Frame
Line up the holes in the frame with the brackets.
Firmly press the frame down onto each bracket.
Fit one side at a time for an easier installation, 1, 2, 3, 4.
Your blind is now installed.
1
4
2
3

How to Operate
To release the blind, rock the handle forwards.
The blind is then free to open and close.
To lock the blind into position, rock the handle backwards.

Fitting the Frame
Adding ‘wrap Tension’ if required
In order for the fabric to roll up, we need to add ‘wrap tension’ at the top of the
blind.
1Remove bottom bar from grooves in side channel, pull down the blind (do
not manually push back up as it needs to raise naturally with the tension).
Insert a 4mm allen key or angled allen drive attachment (R9002 as shown) into
the heaxagon slot in the control end.
Turn ‘anti-clockwise’ to add tension untiol the blind starts to lift.
Tension is complete when the blind is fully opened.
2
3
4

How to remove the blind
1Return blind to the top of the window.
Remove 1 side at a time by depressing button in the bracket and sliding the
frame out.
2
1
2

Visit the Louvolite website to view the links to all of our assembly instructional videos
www.louvolite.com
Also find us on:
S221202
Notes