LSIS iS7 PROFInet User manual

LSIS iS7 Quick Start Guide
1 LSIS iS7 Quick Start Guide
Rev I_6-19-2017
1. iS7 Basic Setup Parameters
The basic drive and motor parameters are shown in Table 1. Set the parameters according to your application.
Table 1. iS7 Basic Setup Parameters
Note: Many applications will not require changes to the basic setup parameters from their default values.
1.1 iS7 Recommended Additional Parameter Changes
The iS7 drive has some default settings the user may want to change to obtain better protection of the drive/motor
and the application. These changes are recommended, but not needed for all applications.
Auto Reset
•Program CON 71 bit 3 to High State (0100).
•Program PRT 08 (Reset/Restart after a fault) to “1” (Yes).
•Program PRT 09 (Number of Retries) to a number between 0 -10.
•Program PRT 10 (Auto Reset Time) to desired time to allow cause of fault to clear and safe starting.
Start on Power Loss
•Program ADV 10 (Power on Start) to “1” (Yes).
Phase Loss
•Program PRT 05 (Phase Loss) to detect input and/or output phase loss.
Note: This parameter is displayed as DIP switches on the iS7. Left bit is the Input, Right bit is the Output.

LSIS iS7 Quick Start Guide
2 LSIS iS7 Quick Start Guide
Rev I_6-19-2017
2. HP to kW Conversion Table
Use the following conversion table to enter the motor HP. Select the closest size the drive allows in kW (motor
power is in kW on most LSIS drives)
Table 3. HP to kW Conversion
3. RPM Entry
Table 4. Poles to RPM
RPM
3600
1800
1200
Poles
2
4
6
Example:
If actual motor RPM is 3450.
•Set Motor Poles = 2
•Set Slip RPM = 150 RPM
HP 1/4 1/2 11.5 2 3 5 7 10 15 20 25 30 40 50 60 75 100 125 150 200 225 250 300 350 400 500 600
kW 0.2 0.4 0.75 1.1 1.5 2.2 3.7 5.5 7.5 11.0 15.0 18.5 22.0 30.0 37.0 45.0 55.0 75 90 110 132 160 185 220 280 315 375 450