Luminite NEXUS NXFOB Safety guide

• Press and hold buons 1 and 2
simultaneously, red LED is on all the me
• Aer 3 seconds, the LED ashed red/green
and the alarm message is sent
• To deacvate the alarm, go to a master unit
and reset the system. You cannot reset the
system using this fob
• Test the baery at least one a week
• To do this, press and hold buon 1, marked with a spot as shown
unl the led changes from green to ashing green/red
• This will transmit the baery condion to the system and be
registered on the data base but only if used in conjuncon with the
IP management system
• If the IP management system is not ed, then change the baery
every year as a precauon
NXFOB - Mobile Panic Button
Set-up and User Guide
Operation
Maintenance

Specications
Wireless Frequency 434.525 Mhz
Transmission Range 200 metres
Battery 12-volt Type 23A
Battery Life 3 years
Activation Press and hold both buons for a minimum of 3 seconds
To set Site=1 / Subnet=1 / Unit=05:
1. Hold buon 2 permanently, all along the next steps, not interrupted!
GREEN LED is On
2. Wait minimally 3s (beer 5s to be sure, there is no indicaon)
3. Now hold buon 1 at the same me. Aer 4s the GREEN LED will
ash quickly indicang that it is ready for entering the rst value
4. Release the buon 1
5. Press buon 1 shortly 7 mes (It selects operaon 7: seng of
Site/Subnet/Unit)
6. Wait unl ashing starts again (Ready for entering the next value)
7. Press buon 1 shortly 1x (for Site=1)
8. Wait unl next ashing
9. Press buon 1 shortly 1x (for Subnet=1)
10. Wait unl next ashing
11. Press buon 1 shortly 5x (for Unit=05)
12. Wait unl GREEN LED goes On permanently
13. You can release buon 2
Programming
020 8368 7887 | inf[email protected]o.uk | www.luminite.co.uk
Luminite Electronics Ltd.
2a Bellevue Road, Friern Barnet,
London, N11 3ER
Designed and Manufactured in the UK