Luverne 495154 User manual

LUVERNETRUCK.COM •PRODUCT SUPPORT: 877.287.8634 •495154-INS-RA •05/18/2020 •ECN6772 •PAGE 1
Product Registration and Warranty
LUVERNE stands behind our products with industry-leading warranties. To get copies of the product
warranties, register your purchase or provide feedback, visit: warranty.curtgroup.com/surveys
INSTALLATION MANUAL 495154
Parts List
Qty Description
1Grip Step™XL running board
3Clamping bracket
6Carriage bolt, 5/16" - 18 x 1"
6Nylock nut, 5/16" - 18
Tools Required
Ratchet Socket, 1/2"
Maintenance
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Product Photo
Torque Specifications
5/16 bolt 10 ft-lbs.
Use above torque setting unless otherwise noted
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.
NOTICE
Visit www.luvernetruck.com for a full-color copy of this
instruction manual, as well as helpful videos, guides and much more!
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
Periodic inspection of your product should be performed
to ensure all hardware and / or components remain secure.
To help prevent damage to the product or vehicle, refer to the specified
torque specifications when securing hardware during the installation process.
Front
This is the second of two manuals
required to complete this installation.
The first manual is included with
your mounting brackets.

LUVERNETRUCK.COM •PRODUCT SUPPORT: 877.287.8634 •495154-INS-RA •05/18/2020 •ECN6772 •PAGE 2
Step 1
Place the Grip Step™XL running board on the
mounting brackets. Place the clamping bracket
inside the running board and secure with the
provided 5/16" hardware.
Repeat for the next two brackets.
Adjust the board so it is parallel with the
vehicle. Tighten all hardware to 10 ft-lbs.
Clamping bracket mounts
inside the running board
Mounting brackets shown
for representation only