LuxCraft 4' Adirondack Glider User manual

4' Adirondack Glider
Assembly Instructions
1 - (A) Seat Assembly
1 - (B) Back Piece
14 - (C) Back Slats
2 - (D) End Piece Assembly
2 - (E) Leg & Armrest Assembly
4 - (F) Glider Hangers
with Bearing & Bolt Assembly
1 - (G) Center Cross Piece
INSTRUCTIONS: *Always match numbers/letters printed on each individual piece. (1 to 1, 2 to 2, A to A, B to B, etc.)
0 1 2 3 4 5 6 7
INCH
A. B. F.
G.
C.
D.
E.
Base Parts List 6 - ⁄" x 4⁄" Bolts
4 - ⁄" x 4" Bolts
4 - ⁄" x 3⁄" Bolts
4 - ⁄" x 3" Bolts
8 - 2⁄" Screws
76 - 1⁄" Screws
18 - ⁄" Nuts
18 - Washers
Hardware List
Step 1 - To assemble
glider base, attach center
cross piece assembly to
end piece assemblies
with four 4⁄" bolts in top
holes. (*Be sure to match
numbers.) Secure with
washers and nuts.
Step 3 - Remove one
washer and nut from
each end of glider arm
assembly. Attach one end
of glider hanger assembly
to each pre-drilled hole in
end piece assembly. Fasten
with washer and nut.
Step 4 - Align the other
end of glider hangers to
bottom holes in leg and
armrest assembly. Fasten
with washer and nut.
Step 2 - For easier
assembly, ip base upside
down to nish assembling
end pieces to center cross
piece assembly. Insert
four 4" bolts in pre-drilled
holes. Secure with washers
and nuts.
Assembled bottom base
ready for leg and glider
hanger assemblies.
The 4" bolts should be
inserted from bottom up.
The bearing and bolt
sequence (Step 3) should
be: bolt, bearing, glider
arm, bearing, nut, washer,
glider leg, washer, and
last of all nut.
continued on back

INSTRUCTIONS: *Always match numbers/letters printed on each individual piece. (1 to 1, 2 to 2, A to A, B to B, etc.)
4' Adirondack Glider
Assembly Instructions
Make sure the small part of
armrest is pointed towards
the long end of base.
Position back slats to
prepare for Step 5.
Position seat and back
assemblies to prepare for
Step 6.
Step 6 - Assemble seat and
back with four 3⁄” bolts.
Put two in center and one
in top hole on each end.
Secure with washer and
nut.
Step 7 - Slide seat and
back between armrests.
*Match numbers.
Step 8 - Put a 4⁄" bolt
in back leg and 3” bolt
in front leg. Secure with
washer and nut.
Step 9 - Then put a 3" bolt
through armrest into seat
back. Secure with washer
and nut.
Step 10 - Install 2⁄"
screws in each
pre-drilled hole in leg
assembly.
Enjoy your glider!
Step 5 - Step 5- Fasten
back slats to back piece
with 1⁄" screws.