LuxCraft Crestville CV-4CPS User manual

*Hex Head Bolt require 2 Washers - between bolt head - product & nut - product.*
5' Classic Pol Swing
(A) - Seat Assembly
(B) - Back Assembly
(C) - Headboard
(D) - Armrest Assembly right side
(E) - Armrest Assembly left side
Hardware
2- 5 16" x 3 1 2" Hex Head Bolt
10 - 5 16" x 2 1 2" Hex Head Bolt
16 - Nuts (5 16")
32 - Washers
4 - 2" Screws
4 - 1 1 2" Screws
8 - 1 2" Screws
1 - Set Swing Chains
1. Attach (C) Headboard to (B) Back Assembly
using eight 1 2" Screws on the back side.
**Be sure to match all letters and/or numbers**
*Hex Head Bolt require 2 Washers - between bolt
head - product & nut - product.*
2. Attach (A) Seat Assembly to (B) Back Assembly
using eight 2 1 2" Hex Head Bolts.
**Be sure to match all letters
and/or numbers**
3. Attach Armrest Assemblies to each
side using 3 1 2" Hex Head Bolt in
bottom front hole inserted from the
inside out.
**Be sure to match all letters and/or numbers**
A.
B.
C.
D.
E.

*Hex Head Bolt require 2 Washers - between bolt head - product & nut - product.*
4. Attach Armrest to Back Support using 2 1 2" Hex Head
Bolt on each side. **Insert bolt from outside**
2" Screws
1 1 2" Screws
5. Install 2" Screws in Front Upright and
1 1 2" Screws to back of Armrest.
6. Attach short end of Chain to Back and long end
through screw eye to bottom of front upright.
Washer - Chain - Washer - Nut