LuxCraft Classic Vinyl Swing Stand User manual

Classic Vinyl Swing Stand Assembly Instructions
1 - (A) Roof Assembly
2 - (B) Side Assemblies
4 - (C) Brace Assemblies
4 - (D) End Caps
Hardware
8 - 3/8" x 7" Stainless Steel Bolts
8 - 3/8" Stainless Steel Nuts
16 - 3/8" Stainless Steel Washers
8 - 3/4" Panhead Screws
56 - 2" Stainless Steel Screws
A
B
C
D
1. Lay Roof Assembly on a Soft Blanket With Slats Facing Down, Attach Side Assembly to
Roof Assembly Using 2 - 7" Bolts 2 - 3/8" Nuts & 4 - 3/8" Washers per Corner. Be Sure to Align all
Predrilled Holes & match all numbers & or letters. Hand Tighten Bolts then Position Swing
Stand Upright & Tighten Bolts.
Washer
Nut
Bolt
Inch
0
1
2
3
4
5
6
7

2. Attach Brace Assemblies to Side & Roof Assembly using
13 - 2" Screws Per Brace, Be Sure To Position Brace As Shown
Below or Predrilled Holes will Not Align with Roof Assembly.
3. Attach End Caps To Top of Posts
Using 2 - 3/4" Screws Per End Cap in Predrilled
Holes.