LuxCraft 5 Plain Poly Glider User manual

3. Attach (D) Bearing Arm Supports to Glider
Base using 4 - 2 1/2" Screws per side, be
sure to match all numbers
& or letters.
Tools Required
5/32 Hex Key (Included)
#2 Square Drive Bit
(Not Included)
1. Attach (F) Front-Back Crosspieces to
(C) Glider Base's Using 14 - 2" Screws
per side, be sure to match all numbers &
or letters.
Hardware
2 - 5/16" x 3 1/2" Stainless Wafer Bolts
2 - 5/16" x 2 1/2" Stainless Wafer Bolts
8 - 5/16" x 2" Stainless Wafer Bolts
4 - Nuts
4 - Washers
8 - 2 1/2" Screws
44 - 2" Screws
1 - 5/32 Hex key
Parts List
1 - (A) Seat Assembly
1 - (B) Back Assembly
2 - (C) Glider Base
2 - (D) Bearing Arm Supports
2 - (E) Armrest's
2 - (F) Front-Back Crosspieces
2 - (G) Crosspiece Supports
2 - (H) Lintels
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
2.Attach (G) Crosspiece Supports to Front-
Back Crosspieces using 4 - 2" Screws per
side, be sure to match all numbers & or
letters.
9/16" Wrench
(Not Included)
Page 1 of 2
5' Plain Poly Glider Assembly Instructions
10/16/ 2017
R.M.
Inch
0
1
2
3
4
5
6
7

6. Attach Back-Seat Assembly to Armrests using
1 - 3 1/2" Wafer Bolt
1 - 2 1/2" Wafer Bolt &
1 - 2" Wafer Bolt
per side,be sure to match all
numbers & or letters, tighten
Wafer Bolts with included Hex Key.
2" Wafer Bolt
5. Attach (B) Back Assembly to (A) Seat Assembly
using 6 - 2" Wafer Bolts, be sure to Match all
numbers & or letters, tighten Wafer
Bolts with included Hex Key.
2" Wafer Bolt
3 1/2" Wafer Bolt
2 1/2" Wafer Bolt
7. Attach (H) Lintels to Armrest Assemblies
using 4 - 2" Screws per side, be sure
to match all numbers & or letters.
4. Attach (E) Armrests to Glider Base using (2-Washers)&(2-Nuts)
per side, be sure to match all numbers & or letters.
"Assembly order is Armrest Assembly-Washer-Nut"
Washer
Armrest Assembly
Nut
Page 2 of 2
5' Plain Poly Glider Assembly Instructions
10/16/ 2017
R.M.