LuxCraft Poly Trash Can User manual

Tools Required
#2 Square Drive Bit
(Not Included)
A
B
C
D
E
F
G
Parts List
1 - (A) Right Side Panel
1 - (B) Front Panel
1 - (C) Left Side Panel
1 - (D) Removable Back Panel
1 - (E) Top Rim
1 - (F) Floor
1 - (G) Roof
Hardware
8 - 1 1/2" Stainless Steel Screws
28 - 2" Stainless Steel Screws
1. Attach (B) Front Panel to (A) & (C)
Side Panels using 4 - 2" Screws in
predrilled Holes. See Notes
Note: Only attach
bottom 2 Screws on
each side as shown.
Middle support Block
Note: Keep Side Panels even
on inside with Bottom Block
& Middle Support Block.
Bottom Block
Page 1 of 2
Poly Trash Can Assembly Instructions
10/20/ 2017
R.M.
Inch
0
1
2
3
4
5
6
7

4. Attach (G) Roof using 8 - 1 1/2" Screws
in predrilled holes.
5. Keep top of removable Back Panel tilted
back & align bottom blocks, tilt top forward
& insert pins through top Rim.
3. Align Top Rim with all
top crosspieces. Keep Pin
Holes on back Side. Install
4 - 2" Screws Per Side Panel
in predrilled holes then install
6 - 2" Screws in predrilled
holes in front Panel.
2. Attach (F) Floor to Side & Front Panels
using 4 - 2" Screws per side Panel & 2 -
2" Screws for Front Panel in predrilled holes.
Keep Blocks
on back side.
Page 2 of 2
Poly Trash Can Assembly Instructions
10/20/ 2017
R.M.