Madison Park Avila User manual

ASSEMBLY INSTRUCTIONS
Description: Avila Counter Stool
Important safety instructions :
• Please read carefully all instructions before assembly.
• For your safety and ease, assembly by two or more adults is recommended.
• Keep instructions for future use.
Pre-assembly:
• Do not discard any contents until assembly is complete to avoid accidentally discarding small parts or
hardware.
• Remove all parts and hardware from box along with any plastic protective packaging.
Parts List
QTY
1
1
1
1
1
Hardware List
QTY
9
9
9
1
4
**Not Provided
DISCLAIMER :
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE.
SELLER IS NOT LIABLE FOR ANY DAMAGES RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED
AFTER PURCHASE.
Page 1 of 3
Description
RIGHT SIDE FOOTREST
LEFT SIDE FOOTREST
FRONT LEG FRAME
P5
BACK LEG FRAME
CUSHION SEAT
Item
P1
P2
P3
P4
H6
Screwdriver
Item
H1
H4
H5
H2
Allen Wrench 5/16"
Wood Screw 8 # X 1 1/2"
Lock Washers 5/16"
H3
Flat Washers 5/16"
Description
Bolts Ø5/16" x 2"

Assembly Procedures:
Step 1.
Attach Front Leg Frame (P3) to the Seat Frame (P5), secure Front Leg Frame (P3) to the Seat Frame (P5) using
Bolt (H1), Allen Wrench (H4) with Lock Washer (H2) and Flat Washer (H3) as shown in the illustration below,
do not fully tighten at this step .
Step 2:
Attach Right Side Footrest (P1) and Left Side Footrest (P2) TO THE Front Leg Frame (P3), secure both
Footrest (P1, P2) to the Front Leg Frame (P3) using Screwdriver(H6) and Wood Screw (H5) as shown in the
illustration below, do not fully tighten at this step .
Step 3 :
Attach Step - 2 assembled part to the Back Leg Frame (P4) as shown below :
Page 2 of 3

Step 4:
Attach Cushion Seat (P5), Left and Right side Footrests (P1 & P2) to the Back Leg Frame (P4) using Allen Wrench
(H4) with Bolt (H1), Lock Washer (H2), Flat Washer (H3) to secure the Cushion Seat and Screwdriver (H6) with
Wood Screw (H5) to ensure the Left and Right Footrest (P1 & P2 ) as shown below :
Step 5 :
Fully tighten all the bolts and screws with Allen Wrench (H4) anad Screwdriver (H6) before turning the chair
over and place it upright on a level surface. Assembly is completed .
ADDITIONAL NOTE ABOUT SAFETY :
BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE.
THEY SHOULD BE INSPECTED AT LEAST EVERY 3 MONTHS AND RE-TIGHTENED AS NEEDED TO PREVENT DAMAGE OR INJURY AND ENSURE STABILITY.
THANK YOU FOR YOUR PURCHASE
Page 3 of 3