Madison Park Salina Recliner User manual

Page 1 of 2
Important safety instructions：
• Please read carefully all instructions before assembling the table.
• For your safety and ease,assembly by two or more adults is recommended.
• Keep instructions for future use.
Pre-assembly：
Parts List
Item
Description DRAWING QTY
P1 Front Legs 2
P2 Right Back Leg 1
P3 Left Back Leg 1
P4 Left Wing 1
P5 Right Wing 1
P6 Backrest 1
P7 Chair Seat 1
Hardware List
Item Description DRAWING QTY
H1 Plastic Washer 2
H2
Bolts
φ5/16*1"
6
H3
Bolts
φ4/16*1-9/16"
2
H4
Lock Washers
φ5/16"
6
H5
Flat Washers
φ4/16"
2
H6
Flat Washers
φ5/16"
6
H7
Allen Wrench
φ4/16"
1
H8
Allen Wrench
φ5/16"
1
ASSEMBLY INSTRUCTIONS
Salina Recliner
• Do not discard any content until assembly completed to avoid accidentally discarding small parts or
hardware
• Take out all parts and hardwares from box .
Step 1.Assemble the chair on a flat,soft surface such as carpet or cloth to prevent scratching the finish. Take out four legs and
hardware from the box which is in the seat.Then turn the chair seat upside down.Extend the Footrest to open and take out
wings from inner box.Return the Footrest to original position.
X2
X6
X2 X1
X1
X6
X2
X1
X2
X1
X6
X1
X1
X1

Page 2 of 2
Thank you for your purchase
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE
PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY.ALWAYS CHECK TO ENSURE
THAT ALL HARDWARE IS KEPT TIGHTENED.
Step 2.Attach the front legs(P1) to chair seat(P7) with plastic washer (H1) by turning the legs clockwise. Using bolts (H2), lock
washers (H4), flat washers (H6), attach back legs (P2,P3) to chair seat (P7).Tighten bolts (H2) with allen wrench (H8).
Step 3. Attach wings (P4&P5) to the backrest (P6) using bolts(H3) and flat washer (H5) with allen wrench (H7).Fully tighten
them until secure.See insert diagram as below.
Step 4.Align female metal bracket located on the sides of the chair backrest(P6) with the prefabricated slide lock gadget on the
chair seat(P7), Insert the small metal arms and push down to lock it (as shown below).
Step 5.Smoothly pat down the fabric on the chair backrest(P6) on both sides of the flap from top to bottom,allowing the velcro
tape to adhere to the flap under the seat of the chair. Assembly is complete.
P1
H1
H2
H4
H6
H8
Remove the plastic
caps from screw heads
before attaching legs.
H3
H5
H7
P6
P7
P6
P6
P6
P7
P7
P7
P7
P1
P6
P3
P2
P1
P1
P1
P7
P4 P6
P4