Madison Park 267521 User manual

ASSEMBLY INSTRUCTIONS
Description : Counter Stool
Important safety instructions:
● Please read carefully all instructions before assembling the stool.
● For your safety and ease, assembly by two or more adults is recommended.
● Keep instructions for future use.
Pre-assembly:
● Do not discard any content until assembly completed to avoid accidentally discarding small parts or
hardware.
● Take out all parts and hardwares from box.
Parts List
Item
A
B
C
D
E
F
Hardware List
Item QTY
a Long Bolts Ø5/16"*3-1/2" 4
b 4
c 1
d 9
e 9
f 1
g 6
h 5
i 1 ** Not Provided
1
Description
QTY
1
Chair Back
Allen Wrench 5/16"
Description
Medium Bolts Ø5/16"*2-1/4"
Short Bolts Ø5/16"*1-3/4"
Lock Washers 5/16"
Flat Washers 5/16"
2
1
2
1
Long Stretcher
Short Stretcher
Front Legs
Seat Cushion
Seat Frame
Wood Screw 8#*1-3/4"
Wood Screw 8#* 5/8"
Screwdriver
Page 1 of 4

Assembly Procedures:
Step 1.
1) Assemble the stool on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
2) Attach Seat Frame (C) to the Chair Back (A) using Bolts (a) for corner block, Bolt (c) at centre , Lock Washers (d)
and Flat Washers (e).
Do not fully tighten at this step.
Step 2. Pushing the Seat Cushion (B) from front to the back till the back of cushion close to the chair back leg tightly,
then attach the Seat Cushion (B) to the Seat Frame (C), tighten Screws (h) with Screwdriver (not provided).
Page 2 of 4

Step 3.
1) Attach Long Stretchers (F) to the leg of Chair Back (A) as shown.
Step 4. Attach one of the Front Leg (D) to the left side of Seat Frame (C) and one of the Long Stretchers (F) using
Allen Wrench (f), Bolts (b), Lock Washers (d) and Flat Washers (e).
Do not fully tighten at this step.
Page 3 of 4

Step 5.
1) Attach one end of Front Stretcher (E) to the Front Leg (D) at the left, then repeat the assembly step 4 to attach
another Front Legs (D) to the right side of Seat Frame (C) and attach with another end of the Front Strechers (E).
2) Make sure all pre-drilled holes at all stretchers downwards, then fully tighten all Bolts (a,b,c) with Allen Wrench (f)
3) Fully tighten all the Screws (g) that securing Stretchers (E,F) to the legs.
Step 6.
1) Turn assembled stool over to an upright position.
2) Assembly is completed.
Failure to follow these instructions may result in misalignment of the bolts during assembly.
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERDAY USE. THEY SHOULD
BE PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY. ALWAYS CHECK
TO ENSURE THAT ALL HARDWARES ARE MAINTAINED TIGHTENED.
Thank you for your purchase
Page 4 of 4