Insert a 10cm cable into Halocode.
Take out the wood boards.
12
Assemble Halocode.
3
Assemble the power module and the dual color sensor.
5
Assemble the wood boards using a rubber band.
8
Pro tips
Use the sandpaper included to
sand a smooth finish on the
wood board before you start
installing it.
4Insert two 10cm cables into the left and right ports on the
dual color sensor.
Bind the two boards using a rubber band.
Add the wood board.
6
7
10 cm
20 cm
10 cm
20 cm
Turn the Micro USB port to
the opening of the wood
board. Put down Halocode.
Follow the same steps to install
the rest screws and studs.
Tighten the stud.
M3 *30mm
M3 *14mm
1:1
M3 *30mm
M3 *14mm
1:1
Tighten the studs.
Put Halocode’s
cable through the
hole as shown.
Rotate
Attach a rubber band.
Put the cable
through the
hole as shown.
1
Combine the
two boards.
2
1
Put the dual color
sensor’s cable through
the hole as shown.
Combine the two boards.
Rotate
Attach a rubber
band.
1
2
Combine the two boards.
2
Building Instructions
