MakerBot Replicator Mini+ User manual

QUICK START GUIDE
1CHECK BOX CONTENTS
USB A-to-B cableSmall MakerBot
PLA Filament spool
MakerBot®Replicator®
Smart Extruder+
Power cord
2SET UP USING OUR APP
SEE REVERSE SIDE FOR OFFLINE SETUP
Make sure to read all safety information before operating your 3D printer.
SUPPORT
Visit our Support page for troubleshooting guides and advanced information.
support.makerbot.com
Go to MakerBot.com/GetStarted
•Download our app to your computer or mobile phone.
•Download the Replicator Mini+ User Manual and review safety information.
•If you’re unable to go online, turn to the reverse side for oine setup.

1LIFT OUT ACCESSORY BOX
AND REPLICATOR MINI+
2REMOVE FOAM
5 ROUTE FILAMENT THROUGH
GUIDE TUBE
6PLUG IN POWER CORD AND POWER ON
3REMOVE CLIPS FROM BELT AND ROD 4INSTALL FILAMENT SPOOL
OFFLINE SETUP
PLEASE BEGIN ON THE REVERSE SIDE
CONNECT TO A COMPUTER USING THE USB CABLE AND OPEN THE MAKERBOT APP