Manrose LED Series User manual

PUB0164 iss:05 05/15
We reserve the right to change specification without notice
Manrose is proudly distributed by Simx Limited
PO Box 14 347, Panmure, Auckland, NZ. Technical Support [phone]
e: [email protected] | www.simx.co.nz | www.manrose.com.au
Fixing clip
Ceiling board
Screw
Fan
chassis
When screw is tightened fixing
clip fingers secure the fan
Diagram 1
INSTALLATION
PRO-SERIES
INSTALLATION INSTRUCTIONS
MANROSE 150MM
EXTRACT-A-LITE/EXTRACT-A-LED DIFFUSER
Please read all instructions before commencing installation.
LED models
DCT3208, DCT3209, DCT3211, DCT3212, DCT3640
Halogen models
DCT1169, DCT1171, DCT1521, DCT1522
Electrical
Supply
Driver Input: 220-240 VAC
Driver Output: 12VDC
Electrical
Supply
Transformer Input: 220-240 VAC
Output: 12VAC
Replacement
driver
FAN5342 Replacement
transformer
FAN2101
Lamp MR16: 12V / 3W high power LED Lamp MR16: 12V / 50W Halogen
Replacement
lamp
LHT0221 Replacement
lamp
FAN0431
Please ensure the corrrect LED lamp and driver OR Halogen lamp and transformer are used for
replacements. The LED model MUST be replaced with an LED lamp and the Halogen model MUST
be replaced with a Halogen lamp. They are not interchangeable.

Installation Instructions
Important: The Halogen model Extract-a-Lite must not work independently of the fan.
1. Cut a 165mm diameter hole in ceiling, (always ensure the hole is cut between ceiling rafters and away
from any wiring or plumbing). Fix the chassis using the 4 screws provided. Use the fixing clips to secure
the grille (See diagram 1).
2. Connect the duct to the spigot of the chassis.
3. For the LED models: Connect LED driver to the Extract-a-LED and to a suitable power supply,
ideally to the switched live of the extractor fan installed. Recommended driver: FAN5342.
Replacement lamp: LHT0221
For the Halogen models: Connect a suitable transformer to the Extract-a-Lite and to a suitable
power supply, ideally to the switched live of the extractor fan installed. Recommended transformer:
FAN2101. Recommended lamp: FAN0431
4. Place the ceiling cover onto the chassis by locating onto the 3 lugs, and twisting clockwise.
5. Never connect mains direct to the lamps.
6. The transformer/driver must be suitable for 230V AC input.
CAUTION: Disconnect the power supply, and be sure that the lamp has fully cooled before removing
or replacing.
IMPORTANT
• Isolate the mains supply before making any electrical connections. This system should be
installed by a qualified electrician.
• When fitting through an external wall, an external grille must be fitted at all times.
• Fan should only be installed by fixed wiring, a flexible cord should not be used.
• The appliance is not intended for use by young children or infirm persons without supervision.
• Young children should be supervised to ensure that they do not play with the appliance.
• Precautions must be taken to avoid the back-flow of gases into the room from the open flue
of gas or other open-fire appliances when mounted in outside windows or walls.
Diagram 2
TYPICAL INSTALLATION
Internal
Extract-a-Lite/
Extract-a-LED
The Shower Fan to be hung
or screwed to the joist
External Grille
Flexible duct