Matica XID-M300 User manual

XID-M300 Quick Start Guide
maticagroup.com
1. 2.
5.
Connect USB cable
• Connect the printer to the computer using the USB cable
when instructed during driver installation.
1. Remove all 4 plastic
locking clips at base
2. Carefully slide box upwards
3. Remove accessories box
4. Remove foam packing
from printer and lift printer
onto desk location
5. Remove plastic protective
films
6. Retain and store all packing
materials for future use.
Any warranty returns
should be sent in original
packaging
1. XID-M printer
2. Power cord
3. USB cable
4. Output hopper
5. Cleaning card
6. Cleaning swab
Please make sure that all
the components and
accessories are included in
the box. If there are missing
or damaged items, please
contact your dealer for
assistance.
23
456
XID-M300 QSG A4 ENG V5
• Follow the online step-by-step guide to
download and install the printer driver.
www.maticagroup.com/install
Or scan the QR code below using
your computer’s webcam to the
installation page and follow the
online instructions.
www.maticagroup.com/register
• Validate your warranty.
• Receive notifications of driver and
firmware updates.
• Gain easy access to support.
6.4.
Register: via mobile
• Scan the QR code to the registration
page and follow the online instructions.
1
3.
• Connect the power cord
• Power ON the printer
SWAB
Power your printer
Register your printer:
Contents check listOpening the printer box
Visit: Download and install driver
CLEANING
CARD

XID-M300 Quick Start Guide
maticagroup.com
9.
7.
8. 10.
Open printer
• Connect the output hopper to the
left hand side of the printer.
Removing input cassette
• Open top lid and locate card
cassette(s). Dual input models
have two cassettes.
Loading cards You are now ready to
start printing!
Card thickness adjustment
Replacing input cassette
Installing ribbon and film
Installing the color ribbon and retransfer film into your printer
Card loading Set up complete
Release the color ribbon cassette (red)
Pull out both
cassette systems
Release the RT film cassette (black)
Color ribbon set up
Red feed spool
Black feed spoolGrey take-up spool
Open lid
To unlock cassette
slide left and lift up
and out
Push cassette
into slot until it
locks in place
locate card holder slider
Located on base
of cassette
Slide adjuster to the
correct card size
Slide to far left load cards, shut lid
Technology card loading orientation
Grey
take-up
spool
Retransfer film set up
Close the front cover
1
1
2 3
2
3
Inserting cassettes into printer
• Using the green knobs and circular
apertures in the cassette as reference
points, place the cassette into the
channels and slide into place.
Connecting the output hopper
1 2
3 4
5