Medel SAMBA Instruction manual

Business Unit Vibrant
SAMBATM Quick User Guide
1. To change the battery, hold the
device between two ngers. First open
one side of the battery case, then open
the other side.
1. First, remove the battery (see abo-
ve). Then place the Samba on an even
surface such as a table and put one
nger on top. First, lift one side of the
cover then lift the other side.
2. Open the battery case until the battery is
completely visible. Carefully turn the Samba
upside-down, allowing the battery to drop out.
2. Remove the cover completely from the audio
processor. Place the new cover on the Samba by
positioning the rear side of the cover on the au-
dio processor rst. Press the cover down: rstly
on the rear side, then on the front side. Make
sure that it snaps into place.
3. Take a new battery and remove the sticky
tab from the top. Place the battery in the
audio processor’s battery case. To activate
the Samba, slide the battery case into the
audio processor with two ngers.
3. Press the sides together to ensure that
the cover is securely in position. Insert the
battery and close the battery case with two
ngers.
Changing the battery
Changing the cover

1. First, remove the battery (see rst
page) and the cover completely (see
rst page).
2. Feed the attachment thread through the
small notch under the battery case. Press the
attachment thread down to xate it in the audio
processor. Use a small pointed object such as a
pencil for doing this.
3. Place the cover on the Samba and insert
the battery. Close the battery case with two
ngers.
Using the hairclip
1. Control Buttons – home & mute
When you press the “home” button you reset your audio processor to the default volume and hearing program,
e.g. if you wear two audio processors and one does not respond to the remote control. With the “mute” button
no audio signals will be transmitted by the SAMBA.
2. Change programs
Press the program change button to switch to the next hearing program. Each program change is indicated by a
beep sequence (one beep for program 1, two beeps for program 2, and so forth).
3. Adjust Volume
Press the volume up button or the volume down button to adjust the volume by one step. Each volume change is
indicated by a beep.
4. General Menu
When you press the volume up button and the volume down button simultaneously, you enter the general menu.
You can navigate through the menu entries by pressing the volume up button or the volume down button.
 .
VIBRANT MED-EL Hearing Technology GmbH
Fürstenweg  |  Innsbruck, Austria | Tel: +--- | vibr[email protected]om medel.com
Using the Remote Control