Medel Samba User manual

Samba audio processor
Quick guide
VAW52130_2.0 (English AUS)

The Samba quick guide is supposed to give you an easy to use reference
for the most common handling topics with the Samba audio processor.
Thanks to the pocket format you can easily carry it with you at all times.
For detailed information on the intended use, indications, contraindica-
tions, warnings and precautions of Samba, or the complete information
on its remote control, please refer to the Samba instructions for use.

1
Table of contents
Samba audio processor................................................................................2
Changing the battery ...................................................................................3
Changing the cover ..................................................................................... 4
Using the hair clip ....................................................................................... 5
The remote control ..................................................................................... 6
Siemens miniTek.......................................................................................... 9
Batteries ..................................................................................................... 10
Basic care of Samba audio processor.........................................................11
Troubleshooting ......................................................................................... 14

2
Samba audio processor
Attachment eyelet
for hair clip Battery compartment
Microphone openings
Interchangeable cover

3
Changing the battery
Hold Samba between
your ngers. First open
one side of the battery
compartment, then
open the other side.
Open the battery
compartment until the
battery is completely
visible. Turn Samba
upside-down carefully,
allowing the battery to
drop out.
Take a new battery and
remove the foil. Place
the battery in the audio
processor’s battery
compartment. Slide
the battery compart-
ment into the audio
processor.
1 2 3

4
Changing the cover
Remove the battery
(see page 3). Place
Samba on an even
surface (e.g. table) and
put one nger on top
(a). First, lift one side of
the cover (b), then lift
the other side (c).
Remove the cover com-
pletely and place the
new cover on Samba.
Press it down, rstly on
the rear side (a), then
on the front side (b).
Insert the battery (see
page 3).
a
a
a
b
a
b c
1 2 3 Press the sides just
below the cover and
behind the opened
battery compartment
together (a) to ensure
that the cover is in the
correct position. Close
the battery compart-
ment.

5
Using the hair clip
Remove the battery and
the cover of your audio
processor (see pages 3
and 4). Pass the attach-
ment eyelet under the
battery compartment.
1 2 3
Insert the attachment
eyelet in the small
notch under the battery
compartment. Press
the eyelet down with a
small pointed object.
Insert the battery and
reattach the cover (see
pages 3 and 4). Close
the battery compart-
ment.

6
The remote control
Volume up/down buttons
Display
Key lock switch
Control buttons
Program change button
1
3
4
2
5

7
1Key lock switch
To prevent any accidental operation
while the remote control is in pockets
or bags, move the key lock switch to
lock position (red color visible).
Program change button
Press the program change button to
switch to the next hearing program.
If you are wearing two hearing instru-
ments, the hearing program will be
changed on both instruments.
2
3
4
Control buttons
You can quickly access two functions
with the control buttons on the right
hand side of the remote control.
Turn hearing instruments on or
off (mute).
Reset to default volume and
hearing program.
Volume up/down buttons
Press the volume up button or the vol-
ume down button to adjust the volume
by one step.
If you are wearing two hearing instru-
ments, the volume will be adapted on
both instruments at the same time.

8
Indicates change of volume
Display
All actions initiated with the remote control are immediately reected on the display.
5
2
1
2
4
3
1
3
4
Indicates change of hearing program
Batteries of the remote control are low
Function of control buttons