Medel ADHEAR System Instruction manual

Hearing has never been so simple: stick the adhesive adapter behind
the ear, click the audio processor onto it and hear the world.
1. Clean the skin behind the ear and
make sure the hairless area offers
enough space to accommodate the
adhesive adapter. Ensure that the skin
is completely dry before you apply the
adhesive adapter.
Place the adhesive adapter in the
positioning tool and remove the
protective lm.
Place the positioning tool behind the
ear so that it lightly touches the ear.
Make sure that there is no hair under
the adhesive adapter.
2. Push the tool down, pressing the
adhesive adapter onto the skin with
your nger; the adhesive adapter will
remain on the skin when the tool is
removed.
Placing the ADHEAR System
1
2
3
4

28968 1.0
3. Connect the audio processor by tilting
it onto the snap connector of the
adhesive adapter. The audio processor
may be adjusted by slightly rotating it
to align with the ear.
4. The retention clip provides additional
xation if needed.
5. Disconnect the audio processor from
the adhesive adapter by pressing it
down on the end closest to the ear, in
this way ensuring that the adhesive
adapter is not pulled away from the
skin.
ADHEAR can be worn discreetly behind
the ear.
The adhesive adapter only needs to be
changed once or twice a week. It can
remain on the skin during sleeping,
showering (or any other water-related
activity) and sports.
MED-EL Medical Electronics
Fürstenweg 77a | 6020 Innsbruck, Austria
of[email protected]om medel.com
5
6
7