Memphis Shades MEM 9958 Operation manual

MEM 9958
SPORTSHIELD MOUNTING KIT FOR H/W VICTORY
INSTRUCTIONS / PARTS LIST
TOOLS REQUIRED: 3/16” Allen wrench (provided)
1. Install the mounting plates onto the windshield using the pre-assembled bolts on the mounting plates. The
rubber grommet should be inserted through the holes in the windshield so that the flat round part of the
washer lays flat on each side of the windshield. On each plate, get both tabs started before you tighten
them. (see Figure 1.1 & 1.2)
Note: *(Wide) – Tabs point in towards each other.
2. Loosely install the four fork clamps 1-3/4” inches apart. (see Figure 2)
3. Loosen the four mounting bolts that are to hold the mounting plates to the fork clamps, and slide the
mounting plates onto the fork clamps. (see Figure 3)
4. Adjust the height, angle, and alignment of the shield. Carefully check clearance from steering stop to stop,
and tighten all mounting bolts.
WARNING: This is a quick disconnect kit. Always tighten down all mounting bolts after removing or
installing the windshield every time.
Fig. 1.1 Left side plate Fig. 1.2 Right side plate Fig. 2 fork clamps Fig. 3 Plate mounting
Care and Cleaning Instructions
To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth,
such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches,
or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing
agents will cause severe damage to your windshield and will void your warranty.
Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh
chemicals. This includes Rain-
X
, brake
f
luid, acetone, and
g
asoline.

MEM-9958
PARTS LIST
H/W VICTORY SPORTSHIELD HARDWARE KIT
PART # DESCRIPTION QTY.
M958 MOUNTING INSTRUCTIONS/PARTS LIST 1
M302 1/4" - 20 X ½”SS SOCKET HEAD CAP SCREW 8
M306 1/4" - 20 X 5/8" SS SOCKET HEAD CAP SCREW 4
M313 3/16” SHORT ARM ALLEN WRENCH COVER 1
M314 3/16” T-HANDLE ALLEN WRENCH 1
M337 3/16” T-HANDLE ALLEN WRENCH COVER 1
M310 3/16" SHORT ARM ALLEN WRENCH 1
M577 MEDIUM INNER ADJ. FORK CLAMP 4
M578 MEDIUM OUTER ADJ. FORM CLAMP 4
M505 BUTTON NUT 4
M504 SOCKET SHOULDER WASHER 4
M543 SANTOPRENE GROMMET 4
M501 BEVELED SOCKET WASHER 4
M1027 LEFT MOUNTING PLATE - WIDE 1
M1028 RIGHT MOUNTING PLATE - WIDE 1
M559 1/8” x3/4” BEVELED SOCKET SPACER 4
MEM9958 03-31-08
Memphis Shades warrants all product components, metal and plastic,
against defects in materials and workmanship for 24 months.
FOR PARTS AND WARRANTY HELP, CONTACT:
MEMPHIS SHADES
P.O. Box 429
Rossville, TN 38066
[phone]
Visit us on the web at www.memphisshades.com or
you can also reach us at
[e-mail]