SRC BMW-R1200GS-02-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: BMW-R1200GS-02-01-AL / BMW-R1200GS-02-02-AL
Part Description: Radiator Guard –BMW R1200 GS
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Mounting Instructions
Step 1:
Unscrew the 3 off screws from
each of the Plastic shield, to pave
the way for mounting the Metal
Radiator Guard, as shown.
The Mounting holes beneath is
exposed for fitment of the
Radiator Guard, as shown.
Drawing view shown here is how
the Plastic shield is mounted
around the periphery of the
Radiator.
The Plastic shield has to be
removed before fitting SRC
Radiator Guard.

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 3:
Repeat the Step 2, as shown, for
mounting the Radiator Guard on the
Right Hand side.
Step 2:
Orient and Align the Radiator
Guard LH (looking from the front
of the Motorbike) and Slip-in the
OE screw from the bottom side
and secure the threads.

Copyright By SRC
Design and Specification are subjected to change
Page 5
Step 4:
Put back the Plastic Shield and it clearly sits over the
left and right periphery of the Radiator Guard and
secure it using the OE screws, as shown.
Final mounted condition of the Radiator Guard, is as
shown, in the drawing below.

Copyright By SRC
Design and Specification are subjected to change
Page 6
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and knowledge,
related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all other
Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour
and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the first
50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8.To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9.If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.