Metra Electronics 95-7810B User manual

METRA. The World’s best kits.™metraonline.com © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
REV. 12/10/2015 INST95-7810B
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
Installation instructions for part 95-7810B
• ISO DDIN radio provision
• Painted matte black
• A) Radio trim panel • B) Radio trim panel brackets • C) Rear support bracket • D (8) #6 x 3/8” Phillips screws
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1729 Antenna Adapter: • 40-HD11
• Panel removal tool • Phillips screwdriver
• 8 mm socket wrench
TOOLS REQUIRED
Honda HR-V 2016-up
95-7810B
ACD
B
Dash Disassembly ................................................. 2
Kit Assembly
–ISO DDIN radio provision ...................................... 3
Table of Contents

95-7810B
2
Dash Disassembly
1. Open the glove box door.
2. Unclip and remove the trim panel
surrounding the radio and a/c vent
located to the left of the radio.
(Figure A)
3. Remove (2) Phillips screws and (1)
8mm screw securing the factory
radio, and then unplug and remove
the radio. (Figure B)
Continue to kit assembly
(Figure A) (Figure B)

95-7810B
1. Attach the radio trim panel brackets
to the radio trim panel using (4)
#6 x 3/8” Phillips screws supplied.
(Figure A)
2. Attach the rear support bracket
to the radio trim panel brackets
using (4) #6 x 3/8” Phillips screws
supplied. (Figure B)
3. Slide the radio into the completed
assembly, and then secure it to the
assembly using the screws supplied
with the radio. (Figure C)
3
Kit Assembly
(Figure A)
(Figure B)
(Figure C)
4. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
5. Reassemble the dash in reverse
order of disassembly.

REV. 12/10/2015 INST95-7810B
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
Installation instructions for part 99-7810B
METRA. The World’s best kits.™metraonline.com © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
IMPORTANT
If you are having difficulties with the installation
of this product, please call our Tech Support line
at 1-800-253-TECH. Before doing so, look over
the instructions a second time, and make sure
the installation was performed exactly as the
instructions are stated. Please have the vehicle
apart and ready to perform troubleshooting
steps before calling.