Metra Electronics 99-7328 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-7328
99-7328
KIT FEATURES
•Recessed DIN Radio Provision with Pocket
•ISO Mount Radio Provision with Pocket
A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate
KIT COMPONENTS
A
Flat Blade Screwdriver/ Panel Removal Tool
•Phillips Screwdriver
1-800-221-0932
©COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION
www.metraonline.com
APPLICATIONS
KIA Sorento
2007-2009
B C
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
•70-7302 - Hyundai harness 2007-up
Antenna Adapter:
•Not required
TOOLS REQUIRED:

Dash Disassembly
-KIASorento2007-2009 ...........................................1
Kit Assembly
-Recessed DIN Mount Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . 2
-ISO Mount Radio Provision with Pocket . . . . . . . . . . .. . . . . . . . . . . . . . . . . . 3
Final Assembly ..........................................4
TABLE OF CONTENTS
99-7328
*Note:
Refer also to the instructions included with the aftermarket radio.
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skills
by enrolling inthe most recognized andrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call 800-354-6782 formore information
and take stepstoward abetter tomorrow.

99-7328 DASH DISASSEMBLY
KIA SORENTO 2007-2009
A
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove the side trim pan-
els. (Tip: start at the bottom of the
panels) (Figure A)
2
Remove (2) Phillips head screws
securing the vent panels then unclip
and remove the (2) vent panels.
(Figure C)
4
Remove (4) Phillips screws securing
the radio. Unplug and remove radio.
5
3
Continue to kit assembly.
C
B
Remove (2) Phillips head screws
securing the radio trim panel. Unplug
and remove panel.
(Figure B)

2
99-7328 KIT ASSEMBLY
B
A
RECESSED DIN RADIO PROVISION WITH POCKET
Slide the DIN cage into the radio hous-
ing and secure by bending the metal
locking tabs outward.
(Figure A)
1
Slide the radio into the DIN cage/hous-
ing assembly until it snaps into place.
(Figure B)
2
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.

3
99-7328 KIT ASSEMBLY
B
A
ISO MOUNT RADIO PROVISION WITH POCKET
Align the holes from the ISO snap in
brackets with the holes in the side of
the radio and mount the brackets to
the radio using screws supplied with
the radio.
(Figure A)
1
Slide the radio/bracket assembly into
the radio housing until the assembly
snaps into place.
(Figure B)
2
Snap the ISO Trim-plate onto the Radio
and housing assembly. (Figure B)
3
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.

99-7328 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative batteryterminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
1
2
3
4
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown belowand the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of anyunused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer.................Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.

99-7328
NOTES
5

99-7328 INSTRUCTIONS
1-800-221-0932
REV. 06/23/09 © COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION INST99-7328
www.metraonline.com