Metra Electronics 95-8904B User manual

METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
APPLICATIONS
KIT FEATURES
KIT COMPONENTS
TOOLS REQUIRED
1-800-221-0932 metraonline.com
METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
REV. 2/03/2010
1-800-221-0932 metraonline.com
INSTALLATION INSTRUCTIONS FOR PART 95-8904BINSTALLATION INSTRUCTIONS FOR PART 95-8904B
SUBARU
LEGACY & OUTBACK
2010
(non-NAV models)
95-8904B
• DDIN radio provision
• ISO stacked provision
• Painted scratch resistant matte black
• A) DDIN Trim Plate • B) DDIN Brackets
• Phillips Screwdriver • Panel Removal Tool • Utility Knife
• Small Flat Blade Screwdriver • Hacksaw (or similar cutting tool)
WIRING & ANTENNA CONNECTIONS (SOLD SEPARATELY)
• 70-8901 Subaru Harness 1990-UP
• 70-7552 Nissan Harness 2007-UP
• 40-SB10 Subaru Antenna Adapter 2005-UP
AB
Note: Minor sub-dash modications required. Part
# 95-8903B does not require these modications.

TABLE OF CONTENTS NOTES
DASH DISASSEMBLY
• 2010 SUBARU LEGACY/OUTBACK . . . . . . . . . 1
KIT ASSEMBLY
• 2010 SUBARU LEGACY/OUTBACK
• DDIN / STACKED ISO HEAD UNIT PROVISION. . 2
*NOTE: Refer Also to the instructions included with the aftermarket radio.
Metra recommends MECP certified
technicians
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
95-8904B 95-8904B

1
2010 SUBARU LEGACY / OUTBACK
95-8904B DASH DISASSEMBLY
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
Unclip and remove the radio trim
panel including the a/c vents.
(Fig. A)
Remove (4) Phillips screws securing
the factory radio.
1
2
3
A
Continue to Kit Assembly
NOTES
95-8904B

2
Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapters
from Metra and AXXESS to inte-
grate your new radio. Re-connect
the negative battery terminal and
test the unit for proper operation.
Attach the Double DIN brackets to
the Double DIN trim plate. (Fig. A)
Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly
and secure the Double DIN head
unit or stacked ISO head units to
the assembly using the screws
supplied with the radio. (Fig. B)
Using an air saw, hacksaw, or simi-
lar cutting tool, cut to the inside of
the radio’s lower mounting holes,
through the plastic and metal
bracket. (Cut on the inside of each
hole as close to the hole as you
can get. If cut properly you may re-
use two bottom factory screws, if
not use self tapping screws on the
bottom.) (Fig. C)
Reassemble dash in reverse order
of disassembly.
95-8904B KIT ASSEMBLY
1
2
3
4
5
DDIN / STACKED ISO
HEAD UNIT PROVISION
A
B
C
NOTES
95-8904B
2010 SUBARU LEGACY / OUTBACK