Metra Electronics 99-3314G User manual

CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
Installation instructions for part 99-3314G
• ISO DIN radio provision with pockets
• Painted gray to match factory dash
• A) Radio trim panel • B) Brackets • C) Upper pocket • D) Pocket • E) (8) #8 x 3/8” Phillips screws
• F) (2) White panel clips
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • LC-GMRC-044 or AX-ADBOX2 and AX-ADGM04
Antenna Adapter: • 40-EU55
TOOLS REQUIRED
Chevy Malibu (with monochrome screen) 2013-up
99-3314G
A B C D E
F
• Panel removal tool • Phillips screwdriver
• Socket wrench (9/32”)

99-3314G
2013 Chevy Malibu
(with monochrome screen)
1. Unclip and lift up the panel
surrounding the shifter. (Figure A)
2. Unplug the two pin connector to
the shift knob then pull up on the
shift knob to remove it and the
panel surrounding it. (Figure A)
3. Unclip and remove the trim panel
surrounding the center stack
including the a/c vents. (Figure B)
4. Remove (12) 9/32” screws
securing everything in the center
of the dash then unplug and
remove all of the components.
5. Remove (4) 9/32” screws securing
the radio chassis.
Dash Disassembly
2014-up Chevy Malibu
(with monochrome screen)
1. Unclip and remove the trim panel
surrounding the center stack
including the a/c vents. (Figure A)
2. Remove (12) 9/32” screws
securing everything in the center
of the dash then unplug and
remove all of the components.
3. Remove (4) 9/32” screws securing
the radio chassis.
(Figure A) (Figure A)
(Figure B)

99-3314G
Kit Assembly
(Figure A) (Figure B) (Figure C)
ISO DIN radio provision
1. Install the panel clips onto the
radio housing panel. (Figure A)
2. Attach the upper pocket with the
provided (4) #8 x 3/8” Phillips
screws. (Figure A)
3. Mount the pocket to the brackets
with the (4) #8 x 3/8” Phillips
screws supplied. (Figure B)
4. Attach the aftermarket radio to
the pocket/bracket assembly with
the screws supplied with the radio
(Figure C)
5. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
6. Mount the new radio assembly into
the dash and reassemble dash in
reverse order of disassembly using
the 99-3314G radio housing panel.