MGI Zip X3 User Manual 1918
9.0 Warranty
9.1 Warranty Policy
The MGI Zip X3 is covered by a limited 2 year manufacturer’s
warranty from the date of purchase. Duration of this warranty is:
– 2 years on parts*
– 2 years on Lithium batteries and chargers
*MGI or an authorised service centre will repair or replace any
parts found to be defective in materials or workmanship under
normal use provided that:
1. The MGI Zip X3 has been properly used, maintained and
regularly serviced [see section 10.5]
2. The replacement or repair is performed by an authorised MGI
service centre or the owner with MGI approval.
3. The Zip X3 has been registered online.
9.2 Warranty Exclusions
The following events will void warranty:
• Any alteration performed by non-authorised people
or companies.
• Fitting of parts or accessories not recommended by MGI.
• Any damage caused by continued operation of the
Zip X3 after it is known to be defective.
• Damage to seat and/or seat support bracket.
• Damage caused by ingress of water into motor/gearbox
and other major components.
• Damage caused by the Zip X3 going into bunkers and other
course hazards.
• All implied warranties [save those preserved by statute] are
excluded. Liability for consequential damages under any and
all warranties are excluded to the extent exclusion is permitted
by law.
9.3 Parts Installed During Warranty
Warranty coverage for components installed during a motorised
Zip X3’s warranty period shall consist of the duration of the Zip X3’s
warranty period, provided the warranty installation is performed
by MGI, an authorised service centre or the Zip X3 owner on
approval. Replacement of parts under warranty will not extend
the warranty of the Zip X3 or parts.
10.0 Preventative Maintenance Program
To properly provide for the continued operation of your MGI Zip
X3, MGI has introduced its Preventative Maintenance Program
[PMP]. The PMP consists of work to be carried out by both the
owner and authorised service centres. To properly maintain the
warranty of your MGI Zip X3, it is essential that this work is carried
out. If the work carried out by the authorised service centre is to
replace parts that are part of the maintenance schedule, the
owner will be charged for the parts and labour. If the work to be
carried out is part of warranty, MGI will bear the cost.
10.1 Cleaning Your Zip X3 [See Maintenance Schedule]
• For years of good operation, your Zip X3 requires care and
attention.
• Keep your Zip X3 clean by using a cloth with warm water and
a mild detergent.
• Do not hose down your Zip X3 under any circumstance, as
the Zip X3 has electronic components.
• Ensure that the seat stem bracket is free from sand.
• Do not submerge your Zip X3 in water as it will cause
irreparable damage.
• Clean the Zip X3 battery base when the battery is removed
from the Zip X3.
10.2 Rear Wheel Axles Maintenance [See Maintenance Schedule]
The rear wheel stub axles need to be lubricated regularly. Remove
the rear wheels by depressing the spring clip and at the same
time pull off the wheel. Apply Petroleum Jelly or light grease to
the stub axles. Use a very small amount as the grease can attract
sand. If you play in sandy conditions you should clean the axle
and regrease fortnightly.
10.3 Upper and Lower Bag Strap Maintenance [See Maintenance
Schedule]
The bag straps should be replaced as per the Service Schedule.
The upper bag strap can be replaced by:
• Removing the left and right hand straps form the upper bag
support
• Undo and remove the screws holding the strap in position
on the bag support
• Remove and replace both bag straps
• Insert bag strap securing screws.
