Microdia FlashMover 28-in-1 USB2.0 User manual

28-in-1 USB2.0 CARD READER
INSTALLATION GUIDE
Thank you for purchasing MICRODIA®FlashMover®28-in-1 USB2.0 Card Reader. The FlashMover®28-in-1
USB2.0 Card Reader works with USB enabled Microsoft Windows 2000, XP or above and Mac OS 9/X and higher
systems. This installation guide contains all the information you need to install your FlashMover®28-in-1 USB2.0
Card Reader.

28-in-1 USB2.0 Card Reader Installation Guide
Nov2006 MICRODIALtd.
For Windows Users
To install the FlashMover®28-in-1 USB2.0 Card Reader on Windows 2000/XP:
1. Plug the card reader into your computer USB port.
2. It is fully Plug-&-Play for Windows 2000/XP, no driver installation needed.
3. A new removable drive is added to your computer after plug in the card reader.
4. Insert flash memory card to access files in your cards.
NOTE: Please check MICRODIA®website, www.microdia.com, for downloading the latest driver.
For Macintosh Users
To install the FlashMover®28-in-1 USB2.0 Card Reader on Mac OS 10.X and above
1. Please go to Mac OS website for upgrading to Mac OS X 10.1.2, then OS X will automatically detects the card
reader.
2. A new removable drive is added to your computer after plug in the card reader.
3. Insert flash memory card to access files in your cards.
NOTE:
- Please check MICRODIA®website, www.microdia.com, for downloading the latest driver.
- Please go to Mac website to update the latest version of Mac OS.
Removing your flash memory cards from the FlashMover®28-in-1 USB2.0 Card Reader
To remove the flash memory cards on Windows system
1. Close any files that are opened and reside on the flash memory cards.
2. You can remove your cards safely after the LED stop blinking
To remove the flash memory card on Mac system
1. The flash memory cards must be [EJECTED] or [UN-MOUNTED] by dragging the card’s disk icon in the trash.
CAUTION: Failure to properly [EJECT] the card before removing the card from the card reader could case data loss
or corruption.
Most problems or technical issues can be resolved by simply visiting our Support Section in MICRODIA®website,
www.microdia.com or send us an email to [e-mail].