MicroNet SP916NL User manual

6
5
7
WEEE Directive & Product Disposal
At the end its serviceable life ,this product should not be treated
as household or general waste. It should be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment, or returned to the supplier for disposal.
P/N 2300-0664
4. Insert the included user manual & utility CD into the CD-ROM
drive and execute “Setup Wizard”.
5. Select your broadband connection type.
4.
6. Modify your wireless setting if required.
7. Select required encryption modes. The default wireless security
settings is disable.7.
8. The router of configuration is completed.
Web-based User Interface
Please login web administrator interface if you need to modify
advanced setting of router. For additional assistance with
configuration, please refer to user manual.
Default Values
IP Address
Subnet Mask
Username
Password
192.168.2.1
255.255.255.0
admin
1234
Communicate via
Quick Installation Guide
Model No.: SP916NL
150Mbps Wireless LAN
Broadband Router
www.micronet.com.tw

Hardware Installation
Attach the power adapter to the 'Power' socket of the router
and wall socket.
Connect the xDSL / cable modem to the WAN port of router
by Ethernet cable.
Connect all computers and network devices to the LAN port
(1~4) of the router.
4
3
1 2
Introduction
Micronet SP916NL, 150Mbps Wireless Broadband Router, delivers
next generation high speed and cost effective wireless solution. It
is compliant with IEEE 802.11n and backward compatible with
IEEE 802.11b/g. It is ideal for SOHOs where all computers and
network devices can share Internet access through a single
xDSL/cable modem. In addition, the scope of the network can be
easily expanded by connecting the router to a hub or a switch.
Package Contents
Prior to the installation of the device, please verify the following
items are in the package:
WLAN Broadband Router
Quick Installation Guide
User Manual & Utility CD
Power Adapter
Detachable Antenna
Configuration
Follow the steps below to configure and set up WLAN Broadband
Router. Acomputer with wired Ethernet connection to the wireless
router is required for first time configuration.
IP Address Configuration
PC/Notebook must belong in the same IP range and subnet.
Follow the steps below to configure IP settings for LAN PC.
1. In the control panel, double click on Network Connections.
Double click on the local area connection (e.g. LAN). The
following screen will appear. Highlight 'Internet Protocol
(TCP/IP)' and click on 'Properties'.
1.
1.
1.
2. Select 'Obtain an IP address automatically' and 'Obtain
DNS server address automatically', then click <OK>.
3. In DOS command, type 'ipconfig' to view information on LAN
connection. Ensure the IP address and subnet mask are on
the same subnet as the router.
2.
2.
2.
Notice!
If you are using the wireless setup wizard under Windows 7, you
might be prompt to enter an 8-digit WPS pin code. Such code is
located at the web interface page shown below.
It is highly recommended that you cancel the wireless setup
wizard from Windows 7 and follow the instructions given in this
guide to setup your wireless network.
Main Menu Wireless Setting WPS setting