Mictrack MC300 User manual

MC300 User Manual V2.0
MC300 Vehicle GPS Tracker
User Manual V2.0
Preface
Thank you for choosing the tracker.This manual shows how to operate the device
smoothly and correctly.Make sure to read this manual carefully before using this product.
Please note that specification and information are subject to changes without prior notice
in this manual. Any change will be integrated in the latest release.The manufacturer
assumes no responsibility for any errors or omissions in this document.

MC300 User Manual V2.0
http://www.mictrack.com
Contents
1. Overview............................................................................................................................................. 1
2. Features.............................................................................................................................................. 1
3. Specification....................................................................................................................................... 2
4. Hardware description....................................................................................................................... 3
4.1 Appearance.............................................................................................................................. 4
4.2 LED Status.............................................................................................................................. 4
4.2.1 Yellow LED-GSM indication..................................................................................... 4
4.2.2 Blue LED-GPS indication......................................................................................... 4
4.2.3 Red LED-Charge indication..................................................................................... 5
4.3 Wiring connections................................................................................................................. 5
4.4 Install the SOS....................................................................................................................... 5
4.5 Connect the Relay(optional)................................................................................................ 5
5. Install the SIM Card........................................................................................................................ 6
6. Work Mode.........................................................................................................................................6
7. Detail Operation................................................................................................................................ 6
7.1 Set the Authorized phone number.................................................................................... 6
7.2 Work Mode Exchange.......................................................................................................... 6
7.3 Change user password.........................................................................................................6
7.4 Request the single position.................................................................................................6
7.5 Request location with Google Map link........................................................................... 7
7.6 Daily Report.............................................................................................................................7
7.7 SOS Alarm...............................................................................................................................7
7.8 Geo-Fence............................................................................................................................... 7
7.8.1 Set Geo Fence........................................................................................................... 7
7.8.2 Turn On Geo-fence................................................................................................... 7
7.8.3 Turn Geo-fence off.................................................................................................... 8
7.9 Low Battery Alarm................................................................................................................. 8
7.10 Cut Off Oil Alarm................................................................................................................ 8
7.11 Power OFF alarm................................................................................................................ 8
7.12 Tow alarm..............................................................................................................................8
7.13 Phone Tracking.................................................................................................................... 8
7.14 Time Zone............................................................................................................................. 9
7.15 Over speed Alarm............................................................................................................... 9
7.16 ACC Illegal Start Alarm..................................................................................................... 9
7.17 Sleep Mode........................................................................................................................... 9
7.18 Voice ON/OFF.................................................................................................................... 10
7.19 Set Access Point Name(APN)........................................................................................10
7.20 Set server IP address and Port.................................................................................... 10
7.21 Set Data upload interval time........................................................................................ 10
8. Special Command.......................................................................................................................... 10

MC300 User Manual V2.0
http://www.mictrack.com
1
1. Overview
MC300 is the 2G vehicle tracker support GSM/GPRS.This device can locate and
monitor any remote targets by SMS/App/PC. The user also can remote cut off oil/power
and check the historical record.
It used for vehicle/motorcycle/truck/Vans tracking and fleet management.
2. Features
GSM 850/900/1800/1900MHz Global support
Track by SMS/GPRS/APP
Real-time position inquire
Trajectory tracking
Get the location with Google link
SOS alarm
Remote cut off oil and power (optional)
ACC detection
Inbuilt Motion Sensor
Geo-fence alarm
Low battery alarm
Over-speed alarm
CE Certificate

MC300 User Manual V2.0
http://www.mictrack.com
2
3. Specification
General Specifications
Dimensions
87mm x 50 mm x 12mm
Weight
65g
Battery
Li- Polymer 700mAh, 3.7V
Standby time
Work mode: 1day; Sleep mode: 5days
Operation Voltage
12 to 24V DC
Operation Temperature
-20°C to 80°C
User Interface
Connector (5 pin power wire)
Red: 12V-24V(+)
Black: Ground(-)
Yellow: SOS button
White: dedicated for ignition
Green: dedicated for ACC
USB port
Configuration the device or upgrade firmware
GSM Antenna
Internal Only
GPS Antenna
Internal Only
Indicator LED
GPS, GSM, Battery status
GSM/GPS Specifications
12V~24V
Frequency
Quad band: 850/900/1800/1900MHz
Power transmission
GSM 850: less than 31 dBm
GSM 900: less than 31 dBm
GSM 1800: less than 28 dBm
GSM 1900: less than 28 dBm
Modulation Type
GMSK; 8-PSK
GPS Chipset
56 Channels U-blox7020 All-in-one GPS module
Sensitivity
Autonomous: -147dBm
Hot Start: -156dBm
Reacquisition: -160dBm
Tracking: -162dBm
Position Accuracy
10m
TTFF(Open Sky)
Cold start: 27s
Warm start: 27s
Hot start: 1s

MC300 User Manual V2.0
http://www.mictrack.com
3
Air Interface Protocol
Transmit Protocol
TCPIP
Scheduled Timing Report
Scheduled Timing Report
Geo-fence
Geo-fence
Power On/Off Report
Report when the device is powered on or off
Low Power Alarm
Alarm when battery is low
SOS/Emergency:
SOS alarm when function key is pressed
Over Speed Alarm
Alarm when car is over speed
4. MC300 and Accessories
Standard accessories
Optional accessories

MC300 User Manual V2.0
http://www.mictrack.com
4
5. Hardware description
5.1 Appearance
5.2 LED Status
5.2.1 Yellow LED-GSM indication
5.2.2 Blue LED-GPS indication
Status
Description
Light On
GSM work
Flash
No GSM network or SIM card not detected
Status
Description
Flash
GPS No Work or No GPS Signal
Light On
GPS Work

MC300 User Manual V2.0
http://www.mictrack.com
5
5.2.3 Red LED-Charge indication
5.3 Wiring connections
Red - 12V-24V(+)
Black - Ground(-)
Yellow - SOS button(red wire)
White - Engine immobilizer (-) ( optional connection)
Green - ACC Detect, stop battery charge while vehicle off.
5.4 Install the SOS
Red: connect to yellow of Power wire
Black: connect to black of power wire
5.5 Connect the Relay(optional)
The White wire is control the fuel of the car and connect to pin 86 of relay. Pin 85 of
relay connect to supply 12V power (please note working volt of the relay is consistent with
working volt of the product). Pin 30 and Pin 87a are always closed and connect fuel
channel power circuit in series. Please install wire in a correct way and we will not be
responsible for device damage caused by wrong installation.
Status
Description
Flash
Charging/working
Light Off
No Power

MC300 User Manual V2.0
http://www.mictrack.com
6
6. Install the SIM Card
Remove the back plate, insert SIM card into SIM slot.Make sure enough charges in
the SIM card.
7. Work Mode
This tracker have two work mode which is SMS and GPRS Mode. SMS mode is for off line
tracking by Mobile phone. GPRS Mode is for on line tracking by computer and mobile
phone .
8. Detail Operation
8.1 Set the Authorized phone number
Command: Cell phone number+password+space+Sequence number(1-3)
Example: 134243923300000 1
Reply: SET OK
Note:
Unauthorized number also can control the tracker, but alarm information only to
Authorized number
The defaulted password is:0000
8.2 Work Mode Exchange
SMS Mode Command:700+ user password
Example:7000000
Reply: SET OK.
GPRS Mode Command:710+ user password
Example: 7100000
Reply: SET OK.
8.3 Change user password
Command: 777+new password+old password (4 figures)
Example: 77712340000
Reply: SET OK
8.4 Request the single position
Command: 666+user password
Example: 6660000
Reply: when the tracker receive the command, then will send the position with longitude
and latitude as follow:
ID: 8151023474
FIX:A
Lat: N22.62963

MC300 User Manual V2.0
http://www.mictrack.com
7
Long: E114.03546
Speed:0KM/H
Date:2015-09-13
Time:04:58:3002
BS:2531 6447
STATE:SMS
8.5 Request location with Google Map link
Command:669+ user password
Example: 6690000
Reply: When the tracker receive the command, tracker will send a Google link to the
sender.
http://maps.google.com/maps?q=22.56312%2c114.09191
FIX:A,2013-12-27
10:15:30
8.6 Daily Report
Command: 665+user password+HHMM
Example: 66500001022
Reply:SET OK.
Close timing report: 665+user password+OFF
Example: 6650000OFF
Reply: SET OFF
Note: HH stands for hour with defined range of [00, 23]. MM stands for minute with
defined range of [00, 59].
8.7 SOS Alarm
When press the SOS button more than 3 seconds, it will send location to authorized
phone number, the information state included "STATE: SOS"
8.8 Geo-Fence
8.8.1 Set Geo Fence
Command: 005+user password+R
Example: 0050000R1000
Reply: SET OK
8.8.2 Turn On Geo-fence
Command: 211+ password
Example: 2110000
Reply: SET OK
Note : The default is 500 meter

MC300 User Manual V2.0
http://www.mictrack.com
8
8.8.3 Turn Geo-fence off
Command: 210+ password
Example: 2100000
Reply: SET OK
Note :Tracker will call and send alarm message to the first authorized phone number.
8.9 Low Battery Alarm
While device detect internal battery is low power, it will send coordinate SMS with
STATE:LOW POWER
8.10 Cut Off Oil Alarm
Open Cut Oil Command: 940+user password
Example: 9400000
Reply : SET OK
Close Cut Oil command : 941+user password
Example:9410000
Reply: SET OK
8.11 Power OFF alarm
Open Power OFF alarm: 011+user password
Example: 0110000
Reply: SET ON
Close Power OFF alarm:011 + user password
Example: 0110000
Reply: SET OK
Note: Tracker will send message to the three authorized phone number and call the first
authorized phone number.
8.12 Tow alarm
Turn on tow truck alert: 181+user password + TX
Example: 181000015
Reply : TOWED ALERT ON
Turn off tow truck alert:180+user password
Example: 1800000
Reply : TOWED ALERT OFF
Note: 1. X is the continuous time, the wide is【15,100】,the unit is second
2.Tracker will send message to the first authorized number
8.13 Phone Tracking
Any phone can call the tracker and tracker will hang off the phone automatically,then
send a position message to the sender, if GPS no work, tracker will send a invalid
message to sender , tracker will send a valid position message to the sender again once

MC300 User Manual V2.0
http://www.mictrack.com
9
GPS work normally by automatically.
8.14 Time Zone
Command:896+user password+space+D+NN
Example:8960000 E08
Reply:SET OK
Note:D takes E or W to indicate east or west time zone respectively. N takes a 2-digit
number (1-12) to indicate time zone number.
8.15 Over speed Alarm
Command:122+user password+space+X
Example: 1220000 100
Reply: SET OK
Close command: 1220000 0
Note: 1. X is speed benchmark value, which is an integral number. unit is KM/H definition
domain of [0, 999].
2. Tracker will call and send alarm message to three authorized number.
8.16 ACC Illegal Start Alarm
Enable ACC Illegal SMS Alarm：886+Password
Example: 8860000
Reply：SET OK
Disable ACC Illegal SMS Alarm：887+Password
Example: 8870000
Reply：SET OK
Enable ACC Illegal Phone Alarm：888+Password
Example: 8880000
Reply: SET OK
Disable ACC Illegal Phone Alarm：888+Password
Example: 8890000
Reply：SET OK
Note : 1.Tracker need connect the ACC wire to the car .
2. Device will send alarm information to three authorized number and call the first
authorized number.
8.17 Sleep Mode
Enable Sleep Mode command : SLEEP+Password+Space+ number
Example : SLEEP0000 1
Reply：SET OK
Disable Sleep command : SLEEP+Password+Space+ 0
Example : SLEEP0000 0
Reply：SET OK

MC300 User Manual V2.0
http://www.mictrack.com
10
Note : 1 is mean the sleep time, the wide is 1-720 , the unit is “minute” , Tracker will close
GPS/GSM/POWER in sleep mode for save power, once shake, tracker will work again.
8.18 Voice ON/OFF
Voice ON command:150+password
Example:1500000
Reply :SET OK
Voice OFF Command:151+password
Example:1510000
Reply :SET OK
Explanation :tracker will call and send message to authorized number in Voice on mode
when take alarm, and will not call but only send message to authorized number in voice
off when take alarm.
8.19 Set Access Point Name(APN)
Command1:803+user password+space+APN
Example: 8030000 CMNET
Command2:803+user password+space+APN+space+APN user name+space+APN password
Example: 8030000 INTERNET INTERNET INTERNET
Reply:SET OK
8.20 Set server IP address and Port
Command:804+user password+space+IP+space+Port
Example: 8040000 192.168.1.1 2014
Reply:SET OK
8.21 Set Data upload interval time
Command:805+user password+space+X(ACC ON)
Example: 8050000 30
Reply:SET OK
Command:809+user password+space+X(ACC OFF)
Example:8090000 60
Reply: SET OK
Note :X is mean interval time, the unit is seconds，the wide is【10,59999】,1 is mean the
when X=0,Close the upload function
9. Special Command
Reset Command: RESET
Restart Command: RESTART
Read Configuration Command: RCONF

MC300 User Manual V2.0
http://www.mictrack.com
11
Tips:
How to setup APN: https://www.mictrack.com/apn-settings-for-mictrack-gps-trackers
How to use Mictrack Server: https://www.mictrack.com/how-to-use-mictrack-server
Global Frequency bands check: https://www.mictrack.com/4g-lte-frequency-bands-list
Note: Please remember to monitor the credit balance of your SIM card, to
avoid confusion or delays in setting up your new unit. This can be a common issue,
especially when initially setting up a new unit, and the unit fails to reply to a correct
SMS command sequence.
If you have any questions please do not hesitate to contact us [e-mail].