Midea MFC-150A15 User manual

OWNER’S MANUAL
Ceiling Fan
MODEL: MFC-150A15
READ AND SAVE THESE INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Version 1.0 2015
Attention: Pictures in the IM are for reference only.

INSTALLATION INSTRUCTIONS-CEILING FAN
NOTICE:
To ensure the success of this installation, be sure to read
the instructions and review the diagram thoroughly before
beginning.
GENERAL
After opening the box, you should find the following parts.
┄one fan motor
┄one down rod
┄one regulator
┄one set of blades
┄two ceiling canopies
Tools required
┄ pliers
┄standard screwdriver
SAFETY PRECAUTIONS
1.Installation by licensed electrician is strongly recommended.
2.Be sure electricity off at main switch before wiring.
3.All wiring must be in accordance with national and local electrical
codes and this fan must be grounded against possible shock.
4.When fan is mounted, blades must be at least 2.3m from floor.
5.Do not allow hands or other objects to contact rotating blades.
INSTALLATION INSTRUCTIONS
1.Before beginning, disconnect power by removing fuse or turning off
circuit breaker.
2.It is essential that the outlet box or structural member from which the fan
is to be suspended will safely support the fan. In view of the torque
and weight factors involved. Some outlet boxes will require additional
strengthening by securing more firmly to wood beams or steel supports.
3.Screw hook through center of outletbox into beam or roist.
Fix Fork Pipe to the motor shaft. Tighten the bolt and nut firmly.
Make sure the cotter pin is inserted and bent.
1
6.
Children should be supervised to ensure that they do not play with the
appliance.
7.
This appliance is not intended for use by person (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.)
8.
If the power supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a hazard.

4.Tie the safety wire as shown in Figure 1～3 and screw safety wire to
the pipe firmly.
5.Safety wire must be tied to ‘U’ hook.
6.Assembly the other end of the pipe with the pulley to the ceiling hook.
Insert the cotter pin and bend
ASSEMBLY INSTRUCTIONS
1. The fan has 3 wires connected to the tip of fan motor.
┄Grounding wire
┄power wires
2. Making sure the down rod is locked with setscrew.
3. Mount the fan blades on the motor with lock washer and screw.
4. Make wiring connections with regulators as shown on fig.2.
5. Slide the canopy up to the ceiling and tighten the screw.
6. Turn on the power and your f
an will be ready for operation.
7. A contact separation of at least 3mm in all poles should be provided
in the fixed wiring for disconnection purpose.
OPERATION INSTRUCTIONS
Remote regulator for ceiling fan is supplied for installation. It is turned
clockwise from the mark “1” to “5” indicating the speed from slow to
fast while turning counter-clockwise from “5” to “1” indicating from
fast to slow. And “0” means off .
2

3

4