miseno MNO183119WS User manual

installationinstruction
UNDERMOUNT SINK STAINLESS STELL
Model: MNO183119WS
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing plumbing fixtures.
MISENO accepts no liability for any damage to the plumbing, sink, countertop, or for personal injury during installation.
Observe all local plumbing and building codes.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation.
For solid surface countertop installation only.
Because the sink specification measurements are approximate and slight variations may occur, we
highly recommend performing any cabinet fabrication procedures with the sink on site.
CAUTION: Metal edges may be sharp! Use caution when handling.
TOOLS AND MATERIALS:
Pencil
Silicone Sealant
(100% Neutral Cure)
JigsawDrillSafety Work
Gloves
Safety
Glasses
Damp Cloth Flathead
Screwdriver
1
REVISED 03/2021

installationinstruction
UNDERMOUNT SINK STAINLESS STELL
Model: MNO183119WS
INSTALLATION
1. Cut out template and place on countertop. Verify the position and desired fit while observing the front overhang
that exists on all countertops.
2. With a pencil, lightly trace along template onto the countertop.
3. Drill a small pilot hole inside the line drawn in Step 2 to allow a starting point for the saw.
4. Carefully cut along the line drawn in Step 2. Contact your countertop fabricator for the best method of
cutting your specific countertop material.
2
REVISED 03/2021

installationinstruction
UNDERMOUNT SINK STAINLESS STELL
Model: MNO183119WS
5. Drill the required faucet holes and install the faucet according to the manufacturer’s instructions.
6. Determine placement of sink clip brackets evenly around the sink perimeter. Pre-drill holes according to
the method recommended for your countertop material.
7. Place the mounting clip anchors into the pre-drilled countertop holes. If necessary, gently tap to insert.
mounting clip anchor
8. Clean the underside of the countertop, ensuring the surface is smooth and free of defects.
9. Apply a bead of silicone sealant along the edge of the underside of the countertop. Position and align
sink within opening. Press sink into silicone seal. Wipe off any excess sealant immediately.
3
REVISED 03/2021

installationinstruction
UNDERMOUNT SINK STAINLESS STELL
Model: MNO183119WS
10. Install the mounting clips and tighten until the sink rim is aligned to the countertop. Ensure that the front
of the sink is parallel to the countertop. Adjust and retighten if needed. Do not overtighten.
mounting clip anchor
mounting clip
screw
sink
countertop
11. Allow the sealant to cure before proceeding.
12. Connect faucet supply lines and drain assembly according to manufacturer’s instructions.
REVISED 03/2021
4