Mitsubishi FR-E5P User manual

TRANSISTORIZED INVERTER
Thank you for purchasing the control panel rear cover and adapter set. This instruction manual
describes handling and considerations for using this product. As errors in handling will cause
unforeseen trouble, before using the product be sure to read this instruction manual thoroughly, so that
the product may be used correctly.
Please ensure that this instruction manual is delivered to the end user of the product.
Safety precautions
Do not touch the inverter when the power is ON, during operation, and for some time
after the power has been turned O , as the inverter will be very hot. ailure to observe
this could lead to burns.
Do not drop the control panel rear cover and adapter set or subject it to a strong impact.
This control panel rear cover and adapter set is used when the control panel is removed from the
inverter main unit and installed on the panel face of another storage panel.
1. Installation
1.1 Installing and remo ing the control panel co er and adapter set
(1) ix by inserting the claws of the control panel
into the control panel rear cover.
To remove, press in on the sides of the
control panel to release the claws.
(2) Insert the adapter into the control panel until
a "click" is heard.
To remove, press in on the claws of the
adapter and pull off.
1.2 Installing the control panel unit on a single panel
Panel cut dimensions drawing
Control
panel
Adapter
Rear cover
M3 screw
Cable
Panel
Hole
M3 screw
Front iew
Control
panel
Adapter
Claw
Claw
Rear cover
Control Panel Rear Co er and Adapter Set
<FR-E5P>
(Unit: mm)

Note) The installation holes of the control panel are blocked. Open by pressing with the
installation screws when installing onto the panel face. Use installation screws with a head
size of 5.5mm (outside diameter)×2mm (height) or less. Do not insert washers.
Installation hole
Installation hole
2. Specifications
(1) Applicable in erter
R-E500 series
(2) Applicable control panel
R-E500 series control panel
(3) Working en ironment
Ambient temperature : －10°C to 50°C (No freezing)
Ambient humidity : 90%RH or less (No dew condensation)
Storage temperature : －20°C to +65°C
(Applicable temperature for short periods such as transportation)
Environment : Indoors (No corrosive gases, inflammable gases, oil mist, or dust)
Altitude and vibration : Less than 1000m above sea level, 5.9m/s2 {0.6G} or less
(Conforms to JIS C 0911)
IB(NA)-66814-A (9709)ROD This document was published in September 1997. The specifications are subject to change without notice.
Model
R-E5P
EIBUN
TORISETSU
Model
code 1A2H38