Mocka Sonata Cot User manual

A B C D
Hardware Supplied
medium
screw x4
short
screw x4
long
screw x8
allen key
x1
LIFT THE COT INTO PLACE, DO NOT DRAG, AS THIS CAN CAUSE DAMAGE
Sonata Cot
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

Ensure the cot is placed at a reasonable distance from
curtains, blinds, heaters and power points. Keep all
medications, string, elastic, small toys or small items,
such as money, out of reach from any position in the
cot.
Assembly
Care must be taken when attaching sides. Ensure all
screws are 100% tight before use, but do not over
tighten screws as this can cause damage to the cot.
Once assembled lift furniture into place, do not drag.
Care and Maintenance
Regularly check all screws for tightness or damage
that could render the cot unsafe. To clean, use a damp
cloth, avoiding the use of detergents or abrasives.
WARNING: TO PREVENT FALLS, THE MATTRESS
BASE OF THIS COT SHOULD BE ADJUSTED TO THE
LOWEST POSITION BEFORE THE CHILD CAN SIT UP.
Recommended mattress size
This cot has been manufactured for use with a
mattress which measures 1300mm long x 690mm
wide x 100mm in thickness. The width and length are
specified because it is important that gaps between
the mattress and the sides and ends of the cot will not
exceed 40mm. This is to minimize the risk of a child’s
limb becoming caught in the gap. The thickness of the
mattress has been specified to ensure that the depth
of the cot is greater than 500mm with the mattress
base in the lower position to minimize the risk of a
child climbing or falling out of the cot.
Mattress Position
Upper level - highest position to be used by newborns,
until shortly before they can sit alone. Under no
circumstances shoud the mattress be in highest
position after the child can sit up.
Lower Level - The mattress base must be in its lowest
position before the baby can sit or stand.
Please follow the manufacturer’s assembly
instructions in detail to ensure the safety
features of the cot are not compromised.
12
Attach the end panels [1] to side panel [2] using 4x long
screws (A) and secure with the allen key (D).
Attach base panel [3] to the rest of the frame using 4x
medium screws (B) and tighten with the allen key (D) as
shown. Ensure you follow the directions for the correct
mattress support height for your child on Page 2.
3
2
1
1
A
A
D
A
AD
E
2
1
1
B
D
B
B
B
B
D
Sonata Cot
3
mocka.co.nz | mocka.com.au
Assembly Instructions

34
Attach side panel [2] to end panels [1] using 4x long
screws (A) and tighten with the allen key (D).
Place 4x short screws (C) into the spare holes on both
panels [1] as shown, and tighten with an allen key. Ensure
the screws are 100% tight before use. Lift furniture into
the desired location, do not drag. You’re done, enjoy!
2
1
D
A
A
AD
A
1
1
1
C
C
D
Sonata Cot
Assembly Instructions
4
mocka.co.nz | mocka.com.au