Mohawk TD-1000-AH User manual
MADE IN THE USA
1000 LB CAPACITY AIR/HYDRAULIC RAISED
5OPERATION
5MAINTENANCE
5PARTS
MOHAWK LIFTS, LLC.
65 VROOMAN AVE., PO BOX 110
AMSTERDAM, NY 12010
TOLL FREE: 1-800-833-2006
LOCAL: 1-518-842-1431
FAX: 1-518-842-1289
INTERNET: www.MOHAWKLIFTS.com
E-MAIL: [email protected]
TD-1000-AH 7-2010.doc
Rev Date 7/2010
Part #601-800-0XX
READ MANUAL
THOROUGHLY BEFORE
INSTALLING,
OPERATING OR SERVICING
THIS LIFT !!
Deliver these instructions to lift
owner/user/employer along with
other instructional materials
furnished with this lift.
TD-1000-AH Tire Dolly
HAVE A QUESTION?
Call your local
Mohawk distributor
For parts, service and technical support.
Distributor Place Card Here
Please have this unit’s model and serial number when calling for service.
Model Number ______________________
Serial Number ______________________
OR CONTACT:
MOHAWK LIFTS, LLC.
65 Vrooman Ave.
P.O. Box 110
Amsterdam, NY 12010
Toll Free: 1-800-833-2006
Local: 1-518-842-1431
Fax: 1-518-842-1289
Internet: www.MOHAWKLIFTS.com
E-Mail: [email protected]
SAFETY WARNINGS FOR TIRE DOLLIES:
WARNING: DO NOT LOAD THIS WHEEL DOLLY BEYOND ITS RATED
CAPACITY. OVERLOADING CAN CAUSE DAMAGE TO OR FAILURE OF
THE PRODUCT. APPLY LOAD AS CLOSE TO THE VERTICAL PORTION
OF THE LIFTING MEMBER AS POSSIBLE. BEFORE MOVING THE LOAD,
LOWER THE LIFTING ARMS AND ASSURE THAT THE LOAD IS
CENTERED AND SECURED WITH A LOAD RESTRAINT DEVICE.
THIS WHEEL DOLLY IS DESIGNED FOR USE ONLY ON HARD LEVEL
SURFACES CAPABLE OF SUSTAINING THE LOAD. USE ON OTHER
THAN HARD LEVEL SURFACES CAN CAUSE INSTABILITY AND
POSSIBLE LOSS OF LOAD.
FAILURE TO HEED THESE WARNINGS MAY RESULT IN LOSS OF LOAD,
DAMAGE TO THE WHEEL DOLLY, AND/OR FAILURE RESULTING IN
PERSONAL INJURY OR PROPERTY DAMAGE.
NO ALTERATIONS TO THE WHEEL DOLLY SHALL BE MADE.
STUDY, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS.
INSTRUCTIONS & DIAGRAMS
MOHAWK LIFTS, LLC.
TD-1000-AH
MOHAWK Because Quality Lasts Forever
MOHAWK
MOHAWK LIFTS, LLC. • P.O. Box 110 65
Vrooman Ave • Amsterdam, NY 12010
(800) 833-2006 or (518) 842-1431
www.mohawklifts.com
Model A-7
The A-7 is a 7,000 lb. capacity asymmetric lift that allows full
opening of all vehicle doors as well as total undercar/underdash
access, thanks to Mohawk’s unique “clear floor” design. Low 4”
arms accommodate all imports and low-riding sports cars. Includes
both 3” and 6” adapters.
Models System I, LC-12, LMF-12, TP-16,
TP-18, TP-26 & TP-30
These 10,000 to 30,000 lb. capacity models are the ideal heavy-
duty lifts for up to Class VI trucks. Mohawk’s unique “clear floor”
design makes these the perfect lifts for all fleet applications. Truck
adapters are also standard equipment.
TR-Series Ramp Style Lifts
Standard models from 19,000 to 120,000 lbs. for total under-
vehicle access. Available in 20’, 25’, and 30’ long runways.
Completely operated by a single technician and feature fully
interlocked, redundant safety systems.
Parallelogram Lifts
Standard models from 36,000 to 100,000 lb. capacities with track
lengths from 26’-48’. Available in surface or flush mount with full
under-vehicle access for all trucks, buses and heavy equipment.
MP-Series Mobile Column
Mohawk’s mobile columns are capable of lifting 32,000 to
240,000 lbs. All columns operate together, individually or can be
divided into separate pairs. Adjustable lifting forks accommodate
the widest range of vehicles. No wheel reducer sleeves needed.
A
N
D
V
A
L
I
D
A
T
E
D
Model
MP-18-006
A
N
D
V
A
L
I
D
A
T
E
D
A
N
D
V
A
L
I
D
A
T
E
D
A
N
D
V
A
L
I
D
A
T
E
D
Model A-7
Model TR-75
Model TP-16
A
N
D
V
A
L
I
D
A
T
E
D
Model 50-26-S
J2000 _
OPERATING
INSTRUCTIONS
1. Lift the vehicle to the desired work height and support
the vehicle in accordance with the lift manufacturer's
recommended support procedure and the warnings given
in this manual.
2. Use an under hoist stand rated greater than the weight
of the engine to support the engine before unbolting the
transmission from the engine.
3. Position the transmission jack directly under the
transmission. Depress the large foot pedal up and down in
order to raise the saddle to a height very close to the center
of balance point of the transmission but do not touch the
transmission.
4. Loosen the four bolts that secure the four extension
arms to the saddle. The extension arms are formed in an
"L" so that one arm of the "L" is longer than the other. The
extension arms can be adjusted in and out to help position
the transmission on the saddle. You must determine
whether you want to use the long or short arm of the "L"
shaped extension arms. Now gently raise the saddle so it
supports the transmission. Adjust the four extension arms
in position against the transmission and tighten the four
bolts that secure the arms to the saddle. Fore and aft
saddle tilt adjustments are sometimes necessary to
properly position the transmission on the saddle. Side to
side tilt positioning may be necessary for the same reason
and can be accomplished by activating the side to side tilt
knob.
5. The hook end of the chain should be pulled over the
center of balance portion of the transmission and secured
to the saddle base. Rotate the hook adjustment to take up
the slack in the chain and secure the transmission to the
saddle.
6. Remove the transmission from the engine according to
instructions in the vehicle service manual.
7. Once the transmission has been disconnected from the
engine, very slowly depress the "down" foot pedal to make
sure the jack's saddle and transmission do not hang up on
any undertruck components, wiring, fuel lines, etc.
Continue to lower the jack all the way down.
PREVENTATIVE
MAINTENANCE
1. Always store the jack in a well protected area where it
will not be exposed to inclement weather, corrosive vapors,
abrasive dust, or any other harmful elements. The jack
must be cleaned of water, snow, sand, or grit before using.
2. Lubricate moving parts once a-month with 'a-general -
purpose grease.
3. It should not be necessary to refill or top off the
reservoir with hydraulic fluid unless there is an external
leak. An external leak requires immediate repair which
must be performed in a dirt-free environment by qualified
hydraulic repair personnel who are familiar with this
equipment. Norco Authorized Service Centers are
recommended. IMPORTANT: In
order
to
prevent
seal
damage and
jack
failure, never use alcohol,
hydraulic
brake fluid,
or
transmission
oil
in the jack.
4. Every jack owner is responsible for keeping the jack
label clean and readable. Use a mild soap solution to wash
extemal surfaces of the jack but not any moving hydraulic
components. Contact Norco Industries for a replacement
label if your jack's label is unreadable.
5. Inspect the jack before each use. Do not use the jack if
any component is cracked, broken, bent, shows sign of
damage, or leaks hydraulic fluid. Do not use the jack if it
has loose or missing hardware or components, or is
modified in any way. Take corrective action before using
the jack again.
6. Do not attempt to make any hydraulic repairs unless you
are a qualified hydraulic repair person that is familiar with
this equipment.
A
N
D
V
A
L
I
D
A
T
E
D
A
N
D
V
A
L
I
D
A
T
E
D
Model System IA-10
A
N
D
V
A
L
I
D
A
T
E
D
Model TP-20
Model MP-18-007
Model V-77-30S
A
N
D
V
A
L
I
D
A
T
E
D
Model TR-75
A
N
D
V
A
L
I
D
A
T
E
D
Model 75-32-F
The Lifts You Can’t Wear Out
TWO POST
FOUR POST MOBILE COLUMN
PARALLELOGRAM VERTICAL RISE
MOHAWK LIFT PRODUCTS
Mohawk Lifts, LLC.
P.O. Box 110 • 65 Vrooman Ave
Amsterdam, NY 12010
Phone: (800) 833-2006 • (518) 842-1431
www.mohawklifts.com
Table of contents
Other Mohawk Lifting System manuals
Mohawk
Mohawk USL-600 Guide
Mohawk
Mohawk V-035-A-X User manual
Mohawk
Mohawk LMF-12 User manual
Mohawk
Mohawk V-085-C-X User manual
Mohawk
Mohawk MP-18-24VDC Series User manual
Mohawk
Mohawk ML-220 User manual
Mohawk
Mohawk IA User manual
Mohawk
Mohawk TP-18 User manual
Mohawk
Mohawk TL-7 User manual
Mohawk
Mohawk TP-20 User manual
Popular Lifting System manuals by other brands
Ergoswiss
Ergoswiss SLA 13 Series Operating instruction
Schmalz
Schmalz Jumbo Ergo operating instructions
HOMECARE PRODUCTS
HOMECARE PRODUCTS EZ-ACCESS TRIFOLD Advantage Series Instructions for use
AMGO Hydraulics
AMGO Hydraulics PRO-18 Installation and service manual
The Handy
The Handy 10738 instructions
Pittsburgh Automotive
Pittsburgh Automotive 60659 Owner's manual & safety instructions
Ranger
Ranger RML-600XL Installation and operation manual
Harmar Mobility
Harmar Mobility Pride Outlander Series owner's manual
JLG
JLG LiftPod FS60 Operation, Safety, Service and Maintenance Manual
Aqua Creek Products
Aqua Creek Products EZ Series quick start guide
EAE
EAE KO-II manual
Challenger Lifts
Challenger Lifts Magnum Versymmetric OE-9 Installation, operation & maintenance manual
